Orange County NC Website
Browse       Search
Orange County Health Department Improvements Smith Sinnett / 2024008 <br />Hillsborough, NC Orange County Asset Management Services <br />WALL AND DOOR PROTECTION 10 26 00 - 18 <br />1. Basis-of-Design Product: <Insert manufacturer’s name; product name or designation> or a comparable <br />product by one of the following: <br />2. [Available ]Manufacturers: <br />a. American Floor Products Co., Inc. <br />b. Construction Specialties, Inc. <br />c. IPC Door and Wall Protection Systems; Division of InPro Corporation. <br />d. Korogard Wall Protection Systems; Division of RJF International Corporation. <br />e. Pawling Corporation. <br />3. Color and Texture: [As indicated by manufacturer’s designations] [As selected by Architect from <br />manufacturer’s full range]. <br />4. Mounting: Countersunk screws through factory-drilled mounting holes. <br />2.10 FABRICATION <br />A. Fabricate impact-resistant wall-protection units to comply with requirements indicated for design, dimensions, and <br />member sizes, including thicknesses of components. <br />B. Preform curved semirigid, impact-resistant sheet wall covering in factory for radius and sheet thickness as follows: <br />1. Sheet Thickness of 0.040 Inch: 24-inch radius. <br />2. Sheet Thickness of 0.060 Inch: 36-inch radius. <br />C. Assemble components in factory to greatest extent possible to minimize field assembly. Disassemble only as <br />necessary for shipping and handling. <br />D. Fabricate components with tight seams and joints with exposed edges rolled. Provide surfaces free of wrinkles, chips, <br />dents, uneven coloration, and other imperfections. Fabricate members and fittings to produce flush, smooth, and rigid <br />hairline joints. <br />2.11 METAL FINISHES <br />A. Comply with NAAMM’s "Metal Finishes Manual for Architectural and Metal Products" for recommendations for <br />applying and designating finishes. <br />1. Remove tool and die marks and stretch lines or blend into finish. <br />2. Grind and polish surfaces to produce uniform, directionally textured, polished finish indicated, free of cross <br />scratches. Run grain with long dimension of each piece. <br />B. When polishing is completed, passivate and rinse surfaces. Remove embedded foreign matter and leave surfaces <br />chemically clean. <br />C. Protect finishes on exposed surfaces from damage by applying a strippable, temporary protective covering before <br />shipping. <br />Docusign Envelope ID: 186E0FF8-664C-4A5C-9F97-28196CE69FD1Docusign Envelope ID: 01F429D6-252B-4D8E-984E-70B5432F90BA