Orange County NC Website
Browse       Search
Orange County Health Department Improvements Smith Sinnett / 2024008 <br />Hillsborough, NC Orange County Asset Management Services <br />WALL AND DOOR PROTECTION 10 26 00 - 7 <br />1) Accent Inlay: Nominal 2 inches high by length of rail. <br />e. Double Handrail with Bumper-Rail Profile: 1-1/2-inch- diameter tubes supported by vinyl-covered, <br />continuous retainers; tubes mounted above and below nominal 4-inch- high by 1-1/2-inch- deep, flat- <br />faced bumper rail; supported by continuous retainer and extended mounting brackets. <br />1) Accent Inlay: Nominal 2 inches high by length of rail. <br />f. Color and Texture: [As indicated by manufacturer’s designations] [As selected by Architect from <br />manufacturer’s full range]. <br />4. Retainer: Minimum 0.080-inch- thick, 1-piece, extruded aluminum. <br />5. Mounting Bracket: Extended mounting on [injection-molded plastic] [anodized-aluminum] mounting <br />brackets. <br />6. End Caps and Corners: Prefabricated, injection-molded plastic; color [matching] [contrasting with] cover; <br />field adjustable for close alignment with snap-on cover. <br />7. Accessories: Concealed splices, cushions, and mounting hardware. <br />B. Combination Wood-Plastic Bumper Handrail <Insert drawing designation>: Assembly consisting of solid-wood <br />handrail mounted above plastic bumper rail, both mounted on continuous retainer; with reveal between handrail and <br />bumper rail. <br />1. Basis-of-Design Product: <Insert manufacturer’s name; product name or designation> or a comparable <br />product by one of the following: <br />2. [Available ]Manufacturers: <br />a. American Floor Products Co., Inc. <br />b. Construction Specialties, Inc. <br />c. Pawling Corporation. <br />3. Wood Handrail: 1-1/2 inches in diameter. <br />a. Wood Species: [Red oak] [Maple] [Ash] [Beech]. <br />b. Finish: [Clear] [Stained]. <br />c. Color: [As indicated by manufacturer’s designations] [Match Architect’s samples] [As selected <br />by Architect from manufacturer’s full range]. <br />4. Bumper: Extruded rigid plastic, minimum 0.078-inch wall thickness; [as follows:] [in dimensions and <br />profiles indicated on Drawings.] <br />a. Profile: Flat profile, nominal [4 inches high by 1 inch] <Insert profile and dimensions> deep. <br />b. Color and Texture: [As indicated by manufacturer’s designations] [As selected by Architect from <br />manufacturer’s full range]. <br />c. End Caps and Corners: Prefabricated, injection-molded plastic; color matching bumper; field <br />adjustable for close alignment with snap-on bumper. <br />5. Retainer: Minimum 0.0625-inch- thick, 1-piece, extruded aluminum. <br />6. Reveal: Extruded rigid plastic or vinyl over aluminum retainer. <br />a. Color: [Brass] [Chrome] [As indicated by manufacturer’s designations] [As selected by <br />Architect from manufacturer’s full range]. <br />7. Accessories: Concealed splices, cushion(s), and mounting hardware. <br />Docusign Envelope ID: 186E0FF8-664C-4A5C-9F97-28196CE69FD1Docusign Envelope ID: 01F429D6-252B-4D8E-984E-70B5432F90BA