Orange County NC Website
Browse       Search
DOOR HARDWARE 087100-12 <br />Orange County Health Department Improvements Smith Sinnett / 2024008 <br />Hillsborough, NC Orange County Asset Management Services <br />6.Hydraulic Regulation: By tamper-proof, non-critical valves, with separate adjustment for latch <br />speed, general speed, and backcheck. <br />7.Provide closers with solid forged steel main arms and factory assembled heavy-duty forged <br />forearms for parallel arm closers. <br />8.Pressure Relief Valve (PRV) Technology: Not permitted. <br />9.Finish for Closer Cylinders, Arms, Adapter Plates, and Metal Covers: Powder coating finish <br />which has been certified to exceed 100 hours salt spray testing as described in ANSI <br />Standard A156.4 and ASTM B117, or has special rust inhibitor (SRI). <br />10.Provide special templates, drop plates, mounting brackets, or adapters for arms as required for <br />details, overhead stops, and other door hardware items interfering with closer mounting. <br />2.11 DOOR TRIM <br />A.Manufacturers: <br />1.Scheduled Manufacturer: Ives. <br />2.Acceptable Manufacturers: Burns, Hiawatha. <br />B.Requirements: <br />1.Provide push plates 4 inches (102 mm) wide by 16 inches (406 mm) high by 0.050 inch (1 mm) <br />thick and beveled 4 edges. Where width of door stile prevents use of 4 inches (102 mm) wide <br />plate, adjust width to fit. <br />2.Provide push bars of solid bar stock, diameter and length as scheduled. Provide push bars of <br />sufficient length to span from center to center of each stile. Where required, mount back to <br />back with pull. <br />3.Provide offset pulls of solid bar stock, diameter and length as scheduled. Where required, mount <br />back to back with push bar. <br />4.Provide pulls of solid bar stock, diameter and length as scheduled. Where required, mount <br />back to back with push bar. <br />5.Provide pull plates 4 inches (102 mm) wide by 16 inches (406 mm) high by 0.050 inch (1 mm) <br />thick, beveled 4 edges, and prepped for pull. Where width of door stile prevents use of 4 inches <br />(102 mm) wide plate, adjust width to fit. <br />2.12 PROTECTION PLATES <br />A.Manufacturers: <br />1.Scheduled Manufacturer: Ives. <br />2.Acceptable Manufacturers: Burns, Hiawatha. <br />B.Requirements: <br />1.Provide kick plates, mop plates, and armor plates minimum of 0.050 inch (1 mm) thick, <br />beveled four edges as scheduled. Furnish with sheet metal or wood screws, finished to match <br />plates. <br />2.Sizes of plates: <br />a.Kick Plates: 10 inches (254 mm) high by 2 inches (51 mm) less width of door on single <br />doors, 1 inch (25 mm) less width of door on pairs <br />2.13 OVERHEAD STOPS AND OVERHEAD STOP/HOLDERS <br />Docusign Envelope ID: 186E0FF8-664C-4A5C-9F97-28196CE69FD1Docusign Envelope ID: 01F429D6-252B-4D8E-984E-70B5432F90BA