Orange County NC Website
Browse       Search
Orange County Health Department Improvements Smith Sinnett / 2024008 <br />Hillsborough, NC Orange County Asset Management Services <br />WALL AND DOOR PROTECTION 10 26 00 - 12 <br />g. Tepromark International, Inc. <br />3. Wing Size: Nominal [3/4 by 3/4 inch] [1-1/8 by 1-1/8 inches] [2-1/2 by 2-1/2 inches]. <br />4. Thickness: Minimum [0.050 inch] [0.075 inch] [0.100 inch]. <br />5. Mounting: [Countersunk screws through factory-drilled mounting holes] [Corner clips]. <br />F. Surface-Mounted, Metal Corner Guards <Insert drawing designation>: Fabricated from 1-piece, formed or extruded <br />metal with formed edges; with 90- or 135-degree turn to match wall condition. <br />1. Basis-of-Design Product: <Insert manufacturer’s name; product name or designation> or a comparable <br />product by one of the following: <br />2. [Available ]Manufacturers: <br />a. American Floor Products Co., Inc. <br />b. ARDEN Architectural Specialties, Inc. <br />c. Balco, Inc. <br />d. Boston Retail Products. <br />e. Construction Specialties, Inc. <br />f. IPC Door and Wall Protection Systems; Division of InPro Corporation. <br />g. Pawling Corporation. <br />3. Material: Stainless steel, Type [304] [430]. <br />a. Thickness: Minimum [0.0500 inch] [0.0625 inch] [0.0781 inch]. <br />b. Finish: [Directional satin, No. 4] [Bright annealed]. <br />4. Material: Extruded aluminum, minimum 0.0625 inch thick, with clear anodic finish. <br />5. Material: Brass sheet, minimum 0.0500 inch thick, with [buffed, smooth specular] [fine satin] finish. <br />6. Wing Size: Nominal [1-1/2 by 1-1/2 inches] [2-1/2 by 2-1/2 inches] [3-1/2 by 3-1/2 inches]. <br />7. Corner Radius: [1/8 inch] [3/4 inch]. <br />8. Mounting: [Flat-head, countersunk screws through factory-drilled mounting holes] [Oval head, <br />countersunk screws through factory-drilled mounting holes] [Double-faced, adhesive foam tape] <br />[Adhesive]. <br />2.7 END-WALL GUARDS <br />A. Surface-Mounted, Resilient, Plastic End-Wall Guard <Insert drawing designation>: Assembly consisting of snap-on <br />plastic cover installed over continuous retainer at each corner, with end of wall covered by semirigid, impact-resistant <br />sheet wall covering; including mounting hardware. <br />1. Basis-of-Design Product: <Insert manufacturer’s name; product name or designation> or a comparable <br />product by one of the following: <br />2. [Available ]Manufacturers: <br />a. American Floor Products Co., Inc. <br />b. ARDEN Architectural Specialties, Inc. <br />c. Balco, Inc. <br />d. Construction Specialties, Inc. <br />e. IPC Door and Wall Protection Systems; Division of InPro Corporation. <br />f. Korogard Wall Protection Systems; Division of RJF International Corporation. <br />g. Pawling Corporation. <br />Docusign Envelope ID: 186E0FF8-664C-4A5C-9F97-28196CE69FD1