Orange County NC Website
Browse       Search
Orange County Health Department Improvements Smith Sinnett / 2024008 <br />Hillsborough, NC Orange County Asset Management Services <br />WALL AND DOOR PROTECTION 10 26 00 - 6 <br />3. Cover: Extruded rigid plastic, minimum 0.078-inch wall thickness; [as follows:] [in dimensions and profiles <br />indicated on Drawings.] <br />a. Profile: [Large rounded bullnose profile, nominal 4 inches high by 2 inches] [Flat profile, <br />nominal 4 inches high by 1 inch] deep. <br />b. Color and Texture: [As indicated by manufacturer’s designations] [As selected by Architect from <br />manufacturer’s full range]. <br />4. Retainer: Minimum 0.0625-inch- thick, 1-piece, extruded aluminum. <br />a. Mounting: [Surface mounted directly to wall] [Surface mounted on 1/2-inch- thick cushion <br />spacers] [Extended mounting on injection-molded plastic mounting brackets]. <br />5. End Caps and Corners: Prefabricated, injection-molded plastic; color [matching] [contrasting with] cover; <br />field adjustable for close alignment with snap-on cover. <br />6. Accessories: Concealed splices and mounting hardware. <br />2.4 HANDRAILS <br />A. Impact-Resistant Plastic Handrails <Insert drawing designation>: Assembly consisting of snap-on plastic cover <br />installed over continuous retainer. <br />1. Basis-of-Design Product: <Insert manufacturer’s name; product name or designation> or a comparable <br />product by one of the following: <br />2. [Available ]Manufacturers: <br />a. American Floor Products Co., Inc. <br />b. ARDEN Architectural Specialties, Inc. <br />c. Balco, Inc. <br />d. Construction Specialties, Inc. <br />e. IPC Door and Wall Protection Systems; Division of InPro Corporation. <br />f. Korogard Wall Protection Systems; Division of RJF International Corporation. <br />g. Pawling Corporation. <br />h. Tepromark International, Inc. <br />3. Cover: Minimum [0.078-inch-] [0.100-inch-] thick, extruded rigid plastic; [as follows:] [in dimensions and <br />profiles indicated on Drawings.] <br />a. Single Handrail Profile: 1-1/2-inch- diameter tube with continuous retainer; with 2-inch- wide <br />mounting brackets supporting bottom of rail. <br />b. Flat Bumper-Rail Profile: Nominal 5-1/2-inch- high by 1-1/2-inch- deep bumper rail with flat front <br />side; with 1-1/2-inch- diameter gripping surface and finger recess on back side; with continuous <br />rubber or vinyl bumper cushion(s) centered in the extrusion; supported by continuous retainer and <br />extended mounting brackets. <br />1) Accent Inlay: Nominal 2 inches high by length of rail. <br />c. Angled-Front Bumper-Rail Profile: Nominal 5-1/2-inch- high by 2-inch- deep bumper rail with <br />angled front side; with 1-1/2-inch- diameter gripping surface and finger recess on back side; supported <br />by continuous retainer and extended mounting brackets. <br />d. Single Handrail above Bumper-Rail Profile: 1-1/2-inch- diameter tube supported by vinyl-covered, <br />continuous retainer and mounted above nominal 5-1/2-inch- high by 1-1/2-inch- deep, flat-faced <br />bumper rail; supported by continuous retainer and extended mounting brackets. <br />Docusign Envelope ID: 186E0FF8-664C-4A5C-9F97-28196CE69FD1