Orange County NC Website
Browse       Search
DOOR HARDWARE 087100-14 <br />Orange County Health Department Improvements Smith Sinnett / 2024008 <br />Hillsborough, NC Orange County Asset Management Services <br />1.Provide heavy duty surface mounted overhead stop or holder for interior doors as specified. <br />Provide overhead stops for interior doors and at any door that swings more than 140 degrees <br />before striking wall, open against equipment, casework, sidelights, and where conditions do not <br />allow wall stop, or floor stop presents tripping hazard. <br />2.Where overhead holders are specified provide friction type at doors without closer and positive <br />type at doors with closer. <br />2.14 DOOR STOPS AND HOLDERS <br />A.Manufacturers: <br />1.Scheduled Manufacturer: Ives. <br />2.Acceptable Manufacturers: Burns, ABH. <br />B.Provide door stops at each door leaf: <br />1.Provide wall stops wherever possible. Provide convex type where mortise type locks are used <br />and concave type where cylindrical type locks are used. <br />2.Where a wall stop cannot be used, provide universal floor stops for low or high rise <br />options. <br />3.Where wall or floor stop cannot be used, provide heavy duty surface mounted overhead stop. <br />2.15 SILENCERS <br />A.Manufacturers: <br />1.Scheduled Manufacturer: Ives. <br />2.Acceptable Manufacturers: Steelcraft, Republic. <br />B.Requirements: <br />1.Provide "push-in" type silencers for hollow metal or wood frames. <br />2.Provide one silencer per 30 inches (762 mm) of height on each single frame, and two for each <br />pair frame. <br />3.Omit where gasketing is specified. <br />2.16 DOOR POSITION SWITCHES <br />A.Manufacturers: <br />1.Scheduled Manufacturer: Schlage. <br />2.Acceptable Manufacturers: GE-Interlogix, Sentrol. <br />B.Requirements: <br />1.Provide recessed or surface mounted type door position switches as specified. <br />2.Coordinate door and frame preparations with door and frame suppliers. If switches are being <br />used with magnetic locking device, provide minimum of 4 inches (102 mm) between switch <br />and magnetic locking device. <br />Docusign Envelope ID: 186E0FF8-664C-4A5C-9F97-28196CE69FD1