2025-178-E-AMS-Armor Tuff-Provide and instal armor tuff flooring Efland EMS

Browse Search

Page 2 ARMOR TUFF JOB EXCLUSIONS & CONTRACT 1. Armor Tuff tiles can only be adhered to clean, dry, bare concrete. Armor-Tuff cannot and will not be responsible for adhesion to non- bare concrete surfaces. Failure of underlying sub surface due to degradation, spalling, floor disintegration, rusting, etc. is excluded from warranty. Previously applied coatings, underlayment’s, patches, skim coats, epoxies, quartz type floors or similar surfaces are not covered under warranty . There is no warranty on the back up line striping. 2. A representative may be sent to measure the quoted rooms. The quotations may vary as per the final measurements. 3. If tiles are installed over any of the above-mentioned surfaces and a failure does occur, Armor Tuff will not be held liable for floor not adhering to the underlying floor. 4. Failure to use Armor-Tuff approved adhesive voids warranty. 5. Pricing includes 10% overage/safety factor for cutting & trim waste. For designer series & hidden joint tiles, 20% will be ad ded. 6. Floor surface to be scrubbed & degreased prior to installation. Additional charges will apply for Armor-Tuff installers to perform this task. 7. Floor to be fully clear of equipment, fire gear and anything that would impede the installation. Additional charges will apply for Armor-Tuff installers to perform this task. 8. Armor-Tuff is not responsible for marking and scuffing of tile surface. Floor colors chosen other than ‘black’ can mark or become d iscolored from tire compound additives. 9. Armor-Tuff is not responsible for hydrostatic pressure or excess moisture in a floor which can cause floor failure. Customer is res ponsible for performing a moisture test with Armor-Tuff supplied moisture test kits or supply certified moisture test results from a field-testing service. There is a $100.00 charge for kits supplied by Armor Tuff and credited toward your purchase. Labor warranty cannot be issued without a moisture test pr ior to the installation. 10. In the unlikely event of Armor-Tuff tiles needing replacement on an in-warranty basis, Armor-Tuff is not responsible for shade variations between supplied and current batches of tiles. Shades/colors can vary from batch to batch. It is recommended that customer inventories extra tiles from the installation batch / dye lot. 11. Any return trip because of a floor that was measured improperly by the client and supplied to Armor-Tuff to prepare our quotes and selling prices or additional work to be performed which results in the installer not having enough tiles or materials to complete the job due t o incorrect, or wrong information being supplied by customer will result in a return trip charge along with an extra material charge needed to comp lete the installation. 12. All client personnel must stay clear and out of the way of our installers and to keep the floor free from traffic during the installation. 13. Supplied logos are to be installed in light/foot traffic areas only and not vehicular traffic. Damaged logo tiles or logos are not covered under the warranty. 14. Customer must supply ‘high resolution’ EPS or pdf type files for logo tiles. If proper usable files are not supplied, artist subcontract fee of minimum $250 minimum for re-drawing logo. Our warranty does NOT cover the Logo and must be treated as if it could be damaged. 15. Travel expenses for Armor-Tuff Installers (air, auto expenses, motels, meals, etc.) shall be reimbursed unless otherwise agreed to in advance in writin g. 16. Armor Tuff, LLC has permission of the authorized signer of this contract and the expressed right to use any pictures taken du ring and after the installation of the work performed by our staff for marketing and advertisement purposes. 17. All disputes that are a result of this contract will be argue and decided in the Morris County Court system in the State of NJ. 18. There is a fee of $395.00 to visit and measure a stations floor. This fee will be credited on the purchase of a new Armor Tuff Tile floor. 19. Customer-measured floors are represented to be level within ¼” and to not ‘puddle’ water. Floors requiring leveling repair, labor and materials are additional charge unless otherwise noted above and are limited to 50 square feet. Additional charge for above. 20. Quote valid for 30 days. 21. This quote is based on non-prevailing wage/union rates. If the project requires prevailing union wage rates, additional charges to be applied and invoiced. 22. Customer agrees to the terms set forth on page one and two of this contract. This Agreement and its performance shall be governed by the laws of the State of NJ. All disputes that are a result of this contract will be argued and decided in the Morris County Court System in the State of NJ. Should any provision of this contract be invalidated in whole or in part by any competent authority, such provision shall continue in ef fect only to the extent permitted, however, the remaining provisions shall remain in full force and effect. 23. Customer acknowledges that any replacement of tiles after attic stock is depleted, colors may vary in shades. 24. For self-installations – Full payment must be received before product is shipped. 25. For Armor Tuff Installations – A 50% deposit before product is shipped and balance due at the time of completion. 26. Customer agrees to allow Armor Tuff, the use of pictures, comments, or quotes in their advertisements and on their web site. 27. Customer is responsible to complete a survey form and submit a diagram of the floor area to be installed. Failure to do so voids any responsibility of Armor Tuff due to mistakes or unforeseen problems due to not having the proper information to complete the job. 28. Black tiles installed in front of bay doors may vary from 5 to 7 tiles depending on the width of the walls between bay doors. 29. Fading of color tiles may occur if exposed to extended sunlight. 30. Customer is responsible to provide 50 AMP, 3-phase electric, or a generator with the same output to operate the grinding machines if necessary. Customer is to supply a dumpster or appropriate containers for disposal of ripped up quartz, epoxy, tiles, concrete & debris. 31. For exposed drains standard edge molding results in approx. 3/16" high raised edge at drains. Flush Fitted Drain molding avai lable at additional charge of $10.00 per lineal foot of perimeter. Minimum charge for fitting of flush drain molding $200.00. 32. Invoices not paid in full within 30 voids warranty. 33. Payment due at time of completion. Payments received beyond 10 days voids warranty. This excludes punch list items to be abat ed. 34. Armor Tuff will not be responsible for tiles that become loose due to the moisture content in the station’s floors. 35. Additional Tiles will be delivered to the jobsite for backup of more than the anticipated cuts and waste. These additional ti les will be returned to Armor Tuff minus any attic stock needed. 36. There will be an additional charge of $150 per hour portal to portal for installers to return to install a logo due to custom er not providing artwork in a timely manner. 37. There will be an additional charge for installers to return due to any change orders, regardless of the size and scope of the additional work. Additional charges of $150 per hour portal to portal will apply for labor. Charges for materials and freight both ways apply if applicable. 38. Items stated above are subject to change dependent on conditions. Accepted & Approved: ____________________________________________________Date: _______________________ “LIFETIME WARRANTY” Armor-Tuff Flooring ~ PO Box 446 ~ Florham Park, NJ 07932 ~ 908-917-7697 Docusign Envelope ID: AC23B7F7-345F-4611-801D-B10BD94C462D