2025-127-E-AMS-Comfort Systems USA (Mid Atlantic) LLC-Sportsplex Pool HVAC Unit Replacement

Browse Search

OC Sportsplex Pool HVAC Unit Replacement PDC Project 23022 Pool Dehumidification Unit 23 84 16 - 9 4.Pool Water Temperature Sensor for Smart Pump Option 5.Supply Air Dry Bulb Temperature (With furnace larger than 800 MBH) 2.26 BACNET/IP A.The dehumidifier control panel shall be capable of direct connection to a BACnet/IP-based Building Automation System.With proper connection to the Ethernet network,the dehumidifier shall appear as a native BACnet device. 2.27 REMOTE ACCESS PACKAGE (RAP),WEB-BASED INTERFACE A.The dehumidifier shall be remotely monitored and controlled.All setpoints and monitoring functions listed in the MICROPROCESSOR CONTROLLER paragraph shall be capable of being remotely controlled and monitored from the remote terminal and simultaneously at the dehumidifier control panel.Remote monitoring and control shall be accomplished with a microprocessor-based web server (by PoolPak International)located in the dehumidifier unit control panel.The dehumidifier shall be monitored and controlled from any workstation on the network using standard web browser software. B.Data Logging shall be accomplished via the self-contained microprocessor/file storage capability of the above RAP hardware.The web server shall be capable of storing data in a historical or circular data log. 2.28 ROOF CURB A.The roof curb shall be an "island"design,enclosing the entire bottom surface of the pool dehumidifier unit.It shall be a minimum 14-gauge galvanized steel construction,48-inches high, include a wood nailer,a counter flashing lip and 1/4-inch sponge-rubber gasketing on all mating surfaces.Intermediate supports shall be provided so that no unsupported dimension exceeds 10- feet.The curb shall be coated in a manner similar to the dehumidifier.The curb shall be provided with horizontal supply air and return air openings on both sides as indicated on the Drawings. PART 3 EXECUTION 3.01 FUNCTIONAL FACTORY TEST AND VERIFICATION A.The completed unit shall be completely tested for functionality in the factory before shipment. B.The functional test shall consist of an in-unit test of the controller,inputs,outputs,safeties and the basic sequence of operation.Also,part of the functional test will be verification of the operation of compressor(s),fan(s),associated electrical components and,if furnished,gas furnace controls and the valve actuators for coils.The functional test shall not be construed as a performance or capacity test. C.Each unit will have a record of the test documented with the unit serial number.Field testing of components or the sequence of operation is not a substitute for factory testing. D.A copy of the functional test report shall be maintained on file at the factory and can be furnished upon request. 3.02 INSTALLATION A.Comply with manufacturer's printed instructions except where more stringent requirements are shown or specified and where manufacturer's technical representative directs otherwise. B.Install unit where shown on drawings.Provide 3-feet clearance around sides and 4-feet around compressor compartment of unit for airflow and service.Provide a means for access to all sides of the unit. C.Contractor shall provide all glycol for the systems 3.03 START-UP,OWNER TRAINING &WARRANTY A.All units shall be thoroughly cleaned by the installing contractor in accordance with the manufacturer's instructions,prior to being placed into service. B.Start-up service shall be provided by the equipment manufacturer's authorized representative and shall include complete testing of all controls and unit operation.The agency responsible for start- up shall record the refrigeration system pressures and electrical operating data.Copies of this data Docusign Envelope ID: D4F3B98E-0756-4A0C-A3AD-05AA32D39F1C