Orange County NC Website
Browse       Search
Orange County Architectural Renovations Smith Sinnett / 2023036 <br />Hillsborough, NC Orange County Asset Management Services <br />METAL FABRICATIONS 05 50 00 - 1 <br />SECTION 05 50 00 - METAL FABRICATIONS <br />PART 1 - GENERAL <br />1.1 RELATED DOCUMENTS <br />A. Drawings and general provisions of the Contract, including General and Supplementary Conditions and <br />Division 01 Specification Sections, apply to this Section. <br />1.2 SUMMARY <br />A. This Section includes the following: <br />1. Steel framing and supports for applications where framing and supports are not specified in other <br />Sections. <br />2. Shelf angles. <br />3. Loose bearing and leveling plates. <br />4. Miscellaneous steel trim including <br />B. Products furnished, but not installed, under this Section include the following: <br />1. Loose steel lintels. <br />2. Anchor bolts, steel pipe sleeves, and wedge-type inserts indicated to be cast into concrete or built into <br />unit masonry. <br />C. Related Sections include the following: <br />1. Division 03 Section "Cast-in-Place Concrete" for installing anchor bolts, steel pipe sleeves, wedge-type <br />inserts and other items indicated to be cast into concrete. <br />1.3 <br />1.4 QUALITY ASSURANCE <br />A. Welding: Qualify procedures and personnel according to the following: <br />1. AWS D1.1, "Structural Welding Code--Steel." <br />2. AWS D1.2, "Structural Welding Code--Aluminum." <br />3. AWS D1.3, "Structural Welding Code--Sheet Steel." <br />4. AWS D1.6, "Structural Welding Code--Stainless Steel." <br />1.5 PROJECT CONDITIONS <br />A. Field Measurements: Verify actual locations of walls and other construction contiguous with metal fabrications <br />by field measurements before fabrication and indicate measurements on Shop Drawings. <br />1. Established Dimensions: Where field measurements cannot be made without delaying the Work, <br />establish dimensions and proceed with fabricating metal fabrications without field measurements. <br />Coordinate wall and other contiguous construction to ensure that actual dimensions correspond to <br />established dimensions. <br />2. Provide allowance for trimming and fitting at site. <br />Docusign Envelope ID: 52FACC74-DA96-491B-B0B8-04AC3961737D