2024-390-E-AMS-Brady Services-WCOB Server Room HVAC

Browse Search

Orange County West Campus Office Building -HVAC PDC Project 23020 BAS DIRECT DIGITAL CONTROL SYSTEM 23 09 02 - 2 A.The BMS contractor shall maintain a service organization consisting of factory trained service personnel and provide a list of 10 projects,similar in size and scope to this project,completed within the last five years. B.Materials and equipment shall be the catalogued products of manufacturers regularly engaged in production and installation of automatic temperature control systems and shall be manufacturer's latest standard design that complies with the specification requirements. C.All BAS peer-to-peer network controllers,central system controllers,and local user displays shall be UL Listed under Standard UL 916,category PAZX;Standard ULC C100;and under Standard UL 864 and be so listed at the time of bid.All floor level controllers shall comply,at a minimum, with UL Standard UL 916;Standard UL 864 and be so listed at the time of Bid. 1.05 SUBMITTALS A.Product Submittal Requirements.Meet requirements of Submittal Section on Shop Drawings, Product Data,and Samples.Provide six copies of shop drawings and other submittals on hardware,software,and equipment to be installed or furnished.Begin no work until submittals have been approved for conformity with design intent.Provide drawings as AutoCAD 2004 (or newer)compatible files on optical disk (file format:.dwg,.dxf,.vsd,or comparable)or hard copies on 11”x 17”prints of each drawing.When manufacturer’s cut sheets apply to a product series rather than a specific product,clearly indicate applicable data by highlighting or by other means. Clearly reference covered specification and drawing on each submittal.General catalogs shall not be accepted as cut sheets to fulfill submittal requirements. Select and show submittal quantities appropriate to scope of work. Also include contractor Sequence of Operations as programmed. 1.06 WARRANTY A.Warrant labor and materials for specified control system free from defects for a period of 12 months after final acceptance.Failures on control systems that include all computer equipment, transmission equipment and all sensors and control devices during warranty period shall be adjusted,repaired,or replaced at no additional cost or reduction in service to Owner. B.Work shall have a single warranty date,even if Owner receives beneficial use due to early system start-up.If specified work is split into multiple contracts or a multi-phase contract,each contract or phase shall have a separate warranty start date and period. C.Exception: 1.Contractor shall not be required to warrant reused devices,except those that have been rebuilt or repaired.Installation labor and materials shall be warranted.Demonstrate operable condition of reused devices at time of Engineer’s acceptance. 2.Contractor shall not be required to warrant systems,equipment and devices or software if the damages and/or failures were caused by lack of training,unauthorized use,negligence or deliberate action of other parties,or job site conditions. 1.07 OWNERSHIP OF PROPRIETARY MATERIAL A.Project specific software and documentation shall become Owner’s property.This includes,but not limited to: 1.Graphics 2.Record drawings 3.Database 4.Application programming code PART 2 PRODUCTS 2.01 GENERAL A.All products used in this project installation shall be new and currently manufactured and shall have been applied in similar installations.Do not use this installation as a product test site unless explicitly approved in writing by Owner or Owner's representative.Spare parts shall be available for at least five years after completion of this contract. 2.02 COMMUNICATION Docusign Envelope ID: 8DED1454-68D2-4E36-9FC6-E56FF2124E5D