2024-390-E-AMS-Brady Services-WCOB Server Room HVAC

Browse Search

Orange County West Campus Office Building -HVAC PDC Project 23020 General Commissioning Requirements 01 91 13 - 4 A.A Prefunctional Checklist is required to be filled out for each item of equipment or other assembly specified to be commissioned. 1.No sampling of identical or near-identical items is allowed. 2.These checklists do not replace manufacturers'recommended startup checklists,regardless of apparent redundancy. 3.Prefunctional Checklist forms will not be complete until after award of the contract;the following types of information will be gathered via the completed Checklist forms: a.Certification by installing contractor that the unit is properly installed,started up,and operating and ready for Functional Testing. b.Confirmation of receipt of each shop drawing and commissioning submittal specified, itemized by unit. c.Manufacturer,model number,and relevant capacity information;list information "as specified,""as submitted,"and "as installed." d.Serial number of installed unit. e.List of inspections to be conducted to document proper installation prior to startup and Functional Testing;these will be primarily static inspections and procedures;for equipment and systems may include normal manufacturer’s start-up checklist items and minor testing. f.Sensor and actuator calibration information. 4.PECI (Samples)found at http://www.peci.org/library/mcpgs.htm indicate anticipated level of detail for Prefunctional Checklists. B.Contractor is responsible for filling out Prefunctional Checklists,after completion of installation and before startup;witnessing by the Commissioning Authority is not required unless otherwise specified. 1.Each line item without deficiency is to be witnessed,initialed,and dated by the actual witness;checklists are not complete until all line items are initialed and dated complete without deficiencies. 2.Checklists with incomplete items may be submitted for approval provided the Contractor attests that incomplete items do not preclude the performance of safe and reliable Functional Testing;re-submission of the Checklist is required upon completion of remaining items. 3.Individual Checklists may contain line items that are the responsibility of more than one installer;Contractor shall assign responsibility to appropriate installers or subcontractors,with identification recorded on the form. 4.If any Checklist line item is not relevant,record reasons on the form. 5.Contractor may independently perform startup inspections and/or tests,at Contractor's option. 6.Regardless of these reporting requirements,Contractor is responsible for correct startup and operation. 7.Submit completed Checklists to Commissioning Authority within two days of completion. C.Commissioning Authority is responsible for furnishing the Prefunctional Checklists to Contractor. 1.Initial Drafts: Contractor is responsible for initial draft of Prefunctional Checklist where so indicated in Contract Documents. 2.Provide all additional information requested by Commissioning Authority to aid in preparation of checklists,such as shop drawing submittals,manufacturers'startup checklists,and O&M data. 3.Commissioning Authority may add any relevant items deemed necessary regardless of whether they are explicitly mentioned in Contract Documents or not. 4.When asked to review the proposed Checklists,do so in a timely manner. D.Commissioning Authority Witnessing: Required for: 1.Each piece of primary equipment,unless sampling of multiple similar units is allowed by the commissioning plan. 2.A sampling of non-primary equipment,as allowed by the commissioning plan. E.Deficiencies: Correct deficiencies and re-inspect or re-test,as applicable,at no extra cost to Owner. Docusign Envelope ID: 8DED1454-68D2-4E36-9FC6-E56FF2124E5D