Orange County NC Website
Browse       Search
CHAPEL HILL ORANGE COUNTY VISITORS BUREAU August 12, 2020 <br />308 WEST FRANKLIN, CHAPEL HILL, NC <br />INTERIOR GLASS PARTITION 102310 - 1 <br />SECTION 102310- INTERIOR GLASS PARTITION <br />PART 1 - GENERAL <br />1.1 RELATED DOCUMENTS <br />A. Drawings and general provisions of the Contract, including General and Supplementary <br />Conditions and Division 01 Specification Sections, apply to this Section. <br />B. Door hardware requirements, Division 8, apply to this section. <br />1.2 SUMMARY <br /> A. Frameless glazed interior wall and door assemblies. <br /> <br /> B. Reference Standards <br /> AAMA 611 - Voluntary Specification for Anodized Architectural Aluminum; 2012. <br /> ASTM B221 - Standard Specification for Aluminum and Aluminum-Alloy Extruded <br /> Bars, Rods, Wire, Profiles, and Tubes; 2013. <br /> ASTM B221M - Standard Specification for Aluminum and Aluminum-Alloy Extruded <br /> Bars, Rods, Wire, Profiles, and Tubes [Metric]; 2013. <br /> ASTM C920 - Standard Specification for Elastomeric Joint Sealants; 2014. <br /> ASTM C1036 - Standard Specification for Flat Glass; 2011e1. <br /> ASTM C1048 - Standard Specification for Heat-Strengthened and Fully Tempered Flat <br /> Glass; 2012. <br /> <br />1.3 ADMINISTRATIVE REQUIREMENTS <br /> A. Pre-installation Meeting: Convene at project site seven calendar days prior to scheduled <br /> beginning of construction activities of this section to review section requirements. <br /> 1. Require attendance by representatives of installer, other entities directly affecting, or <br /> affected by, construction activities of this section. <br /> 2. Notify Architect four calendar days in advance of scheduled meeting <br /> <br />1.4 SUBMITTALS <br /> A. Product Data: Manufacturer's descriptive literature for each component in partition assembly. <br /> B. Shop Drawings: Drawings showing layout, dimensions, identification of components, and <br /> interface with adjacent construction. <br /> 1. Include field measurements of openings. <br /> 2. Include Elevations Showing: <br /> a. Locations and identification of manufacturer-supplied door hardware and fittings. <br /> b. Locations and sizes of cut-outs and drilled holes for other door hardware. <br /> 3. Include Details Showing: <br /> a. Requirements for support and bracing of overhead track. <br /> b. Installation details. <br /> c. Appearance of manufacturer-supplied door hardware and fittings. <br /> C. Selection Samples: Two sets, representing manufacturer's full range of available metal <br /> materials and finishes. <br />DocuSign Envelope ID: 775B89AF-3514-4D9E-B148-2FDE4EFF16C2