|
NO WORK IN THIS AREA116666614621644164119' - 7"3DEMOLISHED TO 4" BELOW CEILING AND FINISH AS GYPSUM HEADER3ED-8ED-9ED-7ED-6ED-5ED-4ED-2ED-21ED-22ED-23ED-125577LIMIT OF CEILING TO BE DEMOLISHED1616161616161616161616161616161615' - 4 7/8"555533GENERAL DEMOLITION NOTES:1. ALL CONDITIONS SHALL BE FIELD VERIFIED BY THE CONTRACTOR WHERE DEMOLITION IS TO OCCUR. THE CONTRACTOR SHALL NOTIFY ARCHITECT OF ANY INCONSISTANCIES IN WRITING PRIOR TO STARTING ANY WORK.2. THE CONTRACTOR SHALL BE RESPONSIBLE FOR WEEKLY AND/OR DAILY REMOVAL AND PROPER DISPOSAL OF ALL DEBRIS ACCUMULATED DURING DEMOLITION AND CONSTRUCTION.3. ANY FLOOR, CEILING, WALL OR OTHER MATERIALS INCLUDING FINISHES IN AREAS TO REMAIN ARE THE RESPONSIBILITY OF THE CONTRACTOR TO PROTECT. ANY MATERIALS DAMAGED DURING CONSTRUCTION OR DEMOLITION, SHALL BE RETURNED TO THEIR ORIGINAL STATE, OR IMPROVED AS INDICATED BY THE OWNER OR ARCHITECT, OR REPLACED WITH A NEW MATERIAL TO MATCH ADJACENT MATERIALS, TYPICAL. 4. CONTRACTOR SHALL PATCH AND REPAIR ALL EXISTING SURFACES TO REMAIN AND MATERIALS EXPOSED TO VIEW WHERE OTHER ITEMS OR MATERIALS HAVE BEEN REMOVED.5. REFER TO PLUMBING, MECHANICAL AND ELECTRICAL DRAWINGS FOR ADDITIONAL AND COMPLETE SCOPE OF DEMOLITION THAT MAY OR MAY NOT BE NOTED ON THE ARCHITECTURAL DEMOLITION PLAN AND NOTES.6. CONTRACTOR SHALL REMOVE ALL WALL MOUNTED FIXTURES OR ITEMS WITHIN THE SCOPE OF DEMOLITION UNLESS OTHERWISE NOTED. ALL WALLS SHALL BE REPAIRED, AND VOIDS FILLED AFTER FIXTURE REMOVAL. ALL FINISHES SHALL MATCH ADJACENT SURFACES. REMOVE ALL FOREIGN MATTER, SHELVING, LOOSE DEBRIS INCLUDING TAPE, ADHESIVE, NAILS, SCREWS, ETC. FROM WALLS. SCRAPE, WIRE BRUSH, AND SAND SMOOTH. WASH ALL PAINTED SURFACES TO REMOVE ANY "FILM OR RESIDUE". PREPARE SURFACES TO PROVIDE A MAXIMUM DEGREE OF NEW PAINT ADHESION. PATCH AND REPAIR ALL VOIDS IN PREPARATION FOR NEW FINISHES.7. ALL FIXTURES, WALLS AND PORTIONS OF WALLS SHOWN AS DASHED LINES OR LABELED SHALL BE DEMOLISHED UNLESS ELEMENTS REMOVED OR REPLACED. CONTRACTOR SHALL PROVIDE ADEQUATE SHORING AND BRACING AND IS RESPONSIBLE FOR ANY FAILURE DUE TO LACK OF PROPER BRACING.8. DURING THE BIDDING PROCESS, CONTRACTORS SHALL TAKE NOTE OF EXISTING PLUMBING MECHANICAL, AND ELECTRICAL ITEMS IN AREAS TO BE RENOVATED. ITEMS INCLUDE BUT ARE NOT LIMITED TO WIRES, CONDUITS, PIPES, THERMOSTATS, FIRE ALARM DEVICES, PANEL CANS, ETC. THESE HAVE BEEN IDENTIFIED IN THE DEMOLITION DRAWINGS FOR ARCHITETURE, PLUMBING, MECHANICAL, AND/OR ELECTRICAL. FOR ITEMS NOT SHOWN, CONTRACTOR SHALL WORK WITH THE ARCHITECT AND OWNER TO DETERMINE IF THE ITEM IS STILL IN USE ITEMS WHICH ARE NOTED TO BE REMOVED AND STORED FOR LATER REINSTALLATION SHALL BE TAGGED AND LISTED ON AN ITEMIZED LIST GIVEN TO THE OWNER AND ARCHITECT.9. THE GENERAL CONTRACTOR SHALL COORDINATE THE DEMOLITION OF THE EXISTING BUILDING AREAS WITH THE ARCHITECT AND OWNER. THE CONTRACTOR SHALL COORDINATE AFTER HOURS WORK AND OBTAIN WRITTEN OWNER PERMISSION FOR NIGHT AND WEEKEND WORK.10. ALL EXISTING FIRE EXTINGUISHER AND BRACKETS SHALL REMAIN AND BE INSTALLED IN THEIR CURRENT LOCATION UNLESS SHOWN ON THE PLANS TO RELOCATE.11. CONTRACTOR SHALL PATCH AND FILL IN ANY VOIDS LEFT FROM THE DEMOLITION OF ANY PLUMBING, MECHANICAL, OR ELECTRICAL ITEMS. REFER TO PLUMBING, MECHANICAL, AND ELECTRICAL DRAWINGS FOR COMPLETE SCOPE OF DEMOLITION.DEMOLITION SPECIFIC AREA NOTES:1REMOVE EXISTING BASE, CARPET, VCT, CERAMIC TILE (RESTROOMS) AND/OR ANY OTHER FLOOR FINISH TO THE EXTENT SHOWN. PREPARE FLOORING TO RECEIVE NEW FINISHES PER SPECIFICATION AND THESE CONSTRUCTION DRAWINGS.2345671215REMOVE EXISTING WALL, FRAMING, AND ASSOCIATED PARTS IN ITS ENTIRETY. ASSOCIATED PARTS INCLUDE BUT NOT LIMITED TO DOOR, DOOR FRAME, HARDWARE, TRACK AND SUPPORTS. PREPARE SURROUNDING AREA TO RECEIVE NEW FINISH SPECIFIED OR IF NO FINISH IS SPECIFIED MATCH EXISTING. REMOVE EXISTING GYPSUM WALL TO THE EXTENTS SHOWN. REMOVE EXISTING PEELING PAINT. CONTRACTOR SHALL PREP EXISTING SURFACES AS NECESSARY TO ENSURE THE MAXIMUM ADHESION BETWEEN THE EXISTING SURFACES AND NEW PAINT.REMOVE EXISTING LAY-IN CEILING TILE, GRID, HANGERS AND ASSOCIATED PARTS IN ITS ENTIRETY. PREP AREA TO RECEIVE NEW CEILING.REMOVE EXISTING GYP CEILING, FRAMING, HANGERS AND ASSOCIATED PARTS IN ITS ENTIRETY. PREP AREA TO RECEIVE NEW CEILING.EXISTING HOLLOW METAL WINDOW FRAME TO BE REMOVED AND SALVAGED. REFER TO A1-01 FOR ELEVATION AND LOCATIONS FOR REUSE IN NEW WALLS.REMOVE EXISTING DOOR, FRAME, & HARDWARE IN ITS ENTIRETY. SALVAGE ITEMS TO BE REUSED.REMOVE EXISTING LIGHT FIXTURES AND REPLACE WITH NEW LIGHT FIXTURES. REFER TO ELECTRICAL FOR COMPLETE SCOPE OF DEMOLITION. REFER TO GENERAL DEMO NOTES FOR REQUIREMENTS ON BULB AND BALLAST DISPOSAL.16FURNITURE TO BE REMOVED FROM SPACE AND STORED AT OWNER'S DIRECTIONDEMOLITION LEGEND:DEMOLITION KEYED NOTEDESCRIPTIONSYMBOLEXISTING TO REMAINEXISTING TO BE REMOVED DURING DEMOLITION#T 919 781 8582F 919 781 39794600 Lake Boone TrailSuite 205Raleigh, NC 27607info@smithsinnett.comDRAWN BY:CHECKED BY:DESCRIPTIONDATEIDThis drawing and the design shown is the property of Smith Sinnett Architecture, P.A. the reproduction or use of this property without the written consent of the Architect is prohibited. Any infringement of the ownership rights will be subject to legal action. All copies of this drawing must be returned to the Architect at the completion of the contract.Smith Sinnett Architecture, P.A. 2020THIS DRAWING IS FORMATTED TO BE PRINTED ON A 24" X 36" SHEETC:\Users\Drew\Documents\2020045_OC DSS Skills Europa_Arch_dwilgus@smithsinnett.com.rvt5/26/2020 12:22:14 AMA0-01DEMOLITION PLAN202004520 May 2020CONSTRUCTION DOCUMENTSMA,DWDWORANGE COUNTY, NCDSS SKILLS DEVELOPMENT CENTER UPFIT100 Europa Dr Ste 101, Chapel Hill, NC 27517REGISTEREDARCHITECTURALCORPORATIONNORTHCAROLINAARCHITECTU,PARALEIGH50172CERT. NO.RESINETTNSMIHT1/8" = 1'-0"A0-011DEMO PLANDocuSign Envelope ID: ECCAC5A0-6CC8-4B37-8AD3-89D69F0AE1AE
|