2020-598-E AMS-Muter Construction Europa upfit SDC

Browse Search

Construction Documents 20033 Orange County Europa Center 26 0101 - 4 ELECTRICAL GENERAL PROVISIONS C.Breaker Panels: The new breakers shall have the AIC not less than panel rating. Breakers shall be third party tested before installation. D.Fasteners: Fasteners for supports and hangers shall be made from approved devices. Fasteners for supports to concrete shall be made with one piece malleable iron or wrought steel inserts and keyhole slots for attachment to forms with self drilling expansion shield with approved threads or expansion plugs. E.Identification: Furnish and install engraved laminated phenolic nameplates for all safety switches, panelboards, transformers, switchboards, motor control centers and other electrical equipment supplied for the project for identification. Nameplates shall be securely attached to equipment with self-tapping stainless steel screws; if the screw sharp end is protected; otherwise Rivets shall be used. Letters shall be approximately 1/2 inch high minimum. Embossed, self-adhesive plastic tape is not acceptable for marking equipment. Nameplate material colors shall match existing facility standard. 2.05 RECEPTACLES A.Receptacles shall be industrial heavy-duty grade and of the following manufacturers: Hubbell, Leviton, or Pass & Seymour. All exterior receptacles shall be installed with a hinged outlet cover/enclosure clearly marked “Suitable for Wet Locations While In Use” and “UL Listed”. There shall be a gasket between the enclosure and the mounting surface, and between the hinged cover and mounting plate/base to assure proper seal. All covers shall be Extra Duty rated. 2.06 EQUIPMENT LISTINGS A.All materials and equipment shall be third party listed by an agency accredited by the NCBCC and NC Department of Insurance (NC DOI). The list of accredited agencies may be obtained on NCDOI's web site. PART 3 EXECUTION 3.01 INSPECTION A.If any part of this Contractor's work is dependent for its proper execution or for its subsequent efficiency or appearance on the character or conditions of contiguous work not executed by him, the Contractor shall examine and measure such contiguous work and report to the Architect or Engineer in writing any imperfection therein, or conditions that render it unsuitable for the reception of this work. Should the Contractor proceed without making such written report, he shall be held to have accepted such work and the existing conditions and he shall be responsible for any defects in this work consequent hereon and will not be relieved of the obligation of any guarantee because of any such imperfection or condition. B.Completion of Contract: Systems shall be complete, tested in the presence of the owner’s representative and/or engineer and/or manufacturer’s representative and ready for use with all equipment operating satisfactorily. Submit to the owner the final electrical inspection certificate and the other guarantees ensuring the work meets all requirements and regulations of the authorities and complies with the drawings and specifications. C.After the designer pre-final inspection and confirmation that the final punch list items have been completed. The contractor shall schedule a final electrical inspection with the SCO office. Inspections shall be Monday through Friday unless specifically coordinated with the SCO office. D.Is the responsibility of the electrical contractor to notify the Office of the Local Electrical Inspector, and schedule required inspections including rough-in, above ceiling and final inspections. A “certificate of approval” shall be obtained from the Local Electrical Inspector after project final inspection approval. 3.02 INSTALLATION A.All work shall be performed in a manner indicating proficiency in the trade. B.All conduit, pipes, ducts, etc., shall be either parallel to building walls or plumb where installed in a vertical position and shall be concealed when located in architecturally finished areas. DocuSign Envelope ID: ECCAC5A0-6CC8-4B37-8AD3-89D69F0AE1AE