2020-598-E AMS-Muter Construction Europa upfit SDC

Browse Search

Construction Documents 20033 Orange County Europa Center 26 0101 - 2 ELECTRICAL GENERAL PROVISIONS 1.04 PRODUCT DELIVERY, STORAGE AND HANDLING A.All material and equipment shall be delivered and unloaded by the Contractor within the project site as noted herein or as directed by the Owner. B.The Contractor shall protect all material and equipment from breakage, theft or weather damage. No material or equipment shall be stored on the ground. C.The material and equipment shall remain the property of the Contractor until the project has been completed and turned over to the Owner. D.Where equipment cannot be stored at the site due to exposure to the elements or lack of storage space , the contractor shall store all equipment in a bonded warehouse until the time of installation. 1.05 WORK CONDITIONS AND COORDINATION A.The Contractor shall review the entire set of plans to establish points of connection and the extent of electrical work to be provided in his Contract. B.The contractor is responsible for reviewing the complete set of contract documents. Coordinate all phasing requirements with architectural drawings. Coordinate equipment locations and utility routing with all trades to ensure code compliance and constructibility. C.This Contractor shall be responsible for all electrical work and make final connections to equipment installed in his Contract. It shall be the contractor’s responsibility to protect his work at all times, and all damages resulting from his operations shall be repaired, or damaged portions replaced to the satisfaction of the engineer. All costs shall be borne by the contractor. D.Pipe, conduit and duct chases required for installation of work shall be provided by the General Contractor unless otherwise noted. This Contractor shall be responsible for coordinating the location of all required chases. E.All work shall be coordinated with other trades. Cutting of new work and subsequent patching shall be approved by Architect/ Engineer and shall be at the Contractor's expense with no extra cost to the Owner. F.Carry out all necessary work to ensure the proper coordination of protective devices throughout the electrical system. Wiring and connections shall be tested for continuity, grounds, and short circuits before any equipment or fixtures are energized. Ensure the correct voltage at all point in the system before and after energizing the connected loads. 1.06 GUARANTEE A.Contractor shall unconditionally guarantee his work and all components from a period of one year from the date of final acceptance. He shall remedy without delay any defects in workmanship; repair or replace any faulty equipment which shall arise within the guarantee period to the complete satisfaction of the owner at no additional charge. During the warranty period, the contactor shall provide service, parts, and labor to repair or replace defective parts, modify and adjust equipment controls for the most efficient operation. B.Where extended warranties or guarantees are available from the manufacturer, the Contractor shall prepare the necessary Contract Documents to validate these warranties as required by the manufacturer and present them to the Architect/Engineer. PART 2 PRODUCTS 2.01 MATERIAL QUALITY A.Material and equipment shall be new, unless noted otherwise, of the highest grade and quality and free from defects or other imperfections. Material and equipment found defective shall be removed and replaced at the Contractor's expense. 2.02 CONDUCTORS A.All conductors shall be copper. Aluminum conductors are not acceptable unless specifically noted on plans. Minimum conductor size shall be #12 AWG. Conductors #10 AWG and smaller must be solid. Conductors larger that #10 shall be class B stranded. DocuSign Envelope ID: ECCAC5A0-6CC8-4B37-8AD3-89D69F0AE1AE