Orange County NC Website
Browse       Search
Orange County Southern Expansion Smith Sinnett / 2017027 <br />Phase 1 – Seymour Center Renovation and Addition Orange County <br /> <br />GLAZING 08 80 00 - 7 <br />3. Silicone, ASTM C 1115. <br />4. Thermoplastic polyolefin rubber, ASTM C 1115. <br />5. Any material indicated above. <br />2.6 GLAZING SEALANTS <br />A. General: Provide products of type indicated, complying with the following requirements: <br />1. Compatibility: Select glazing sealants that are compatible with one another and with other <br />materials they will contact, including glass products, seals of insulating-glass units, and glazing <br />channel substrates, under conditions of service and application, as demonstrated by sealant <br />manufacturer based on testing and field experience. <br />2. Suitability: Comply with sealant and glass manufacturers' written instructions for selecting <br />glazing sealants suitable for applications indicated and for conditions existing at time of <br />installation. <br />3. Colors of Exposed Glazing Sealants: As selected by Architect from manufacturer's full range. <br />B. Elastomeric Glazing Sealants: Comply with ASTM C 920 and other requirements indicated for each <br />liquid-applied chemically curing sealant specified, including those referencing ASTM C 920 <br />classifications for type, grade, class, and uses related to exposure and joint substrates. <br />2.7 GLAZING TAPES <br />A. Back-Bedding Mastic Glazing Tapes: Preformed, butyl-based elastomeric tape with a solids content of <br />100 percent; non-staining and nonmigrating in contact with nonporous surfaces; with or without spacer <br />rod as recommended in writing by tape and glass manufacturers for application indicated; packaged on <br />rolls with a release paper backing; and complying with ASTM C 1281 and AAMA 800 for products <br />indicated below: <br />1. AAMA 807.3 tape, for glazing applications in which tape is not subject to continuous pressure. <br />2.8 MISCELLANEOUS GLAZING MATERIALS <br />A. General: Provide products of material, size, and shape complying with referenced glazing standard, <br />requirements of manufacturers of glass and other glazing materials for application indicated, and with a <br />proven record of compatibility with surfaces contacted in installation. <br />B. Cleaners, Primers, and Sealers: Types recommended by sealant or gasket manufacturer. <br />C. Setting Blocks: Elastomeric material with a Shore, Type A durometer hardness of 85, plus or minus 5. <br />D. Spacers: Elastomeric blocks or continuous extrusions with a Shore, Type A durometer hardness required <br />by glass manufacturer to maintain glass lites in place for installation indicated. <br />E. Edge Blocks: Elastomeric material of hardness needed to limit glass lateral movement (side walking). <br />2.9 FABRICATION OF GLAZING UNITS <br />A. Fabricate glazing units in sizes required to glaze openings indicated for Project, with edge and face <br />clearances, edge and surface conditions, and bite complying with written instructions of product <br />manufacturer and referenced glazing publications, to comply with system performance requirements. <br />DocuSign Envelope ID: ECCAC5A0-6CC8-4B37-8AD3-89D69F0AE1AE