Orange County NC Website
Browse       Search
Orange County Southern Expansion Smith Sinnett / 2017027 <br />Phase 1 – Seymour Center Renovation and Addition Orange County <br /> <br />GLAZING 08 80 00 - 4 <br />Category II materials are required by 16 CFR 1201 and regulations of authorities having <br />jurisdiction. <br />G. Glazing Publications: Comply with published recommendations of glass product manufacturers and <br />organizations below, unless more stringent requirements are indicated. Refer to these publications for <br />glazing terms not otherwise defined in this Section or in referenced standards. <br />IGMA Publication for Insulating Glass: SIGMA TM-3000, "Glazing Guidelines for Sealed Insulating <br />Glass Units." <br />H. Insulating-Glass Certification Program: Permanently marked either on spacers or on at least one <br />component lite of units with appropriate certification label of the following testing and inspecting agency: <br />1. Insulating Glass Certification Council. <br />1.7 DELIVERY, STORAGE, AND HANDLING <br />A. Protect glazing materials according to manufacturer's written instructions and as needed to prevent <br />damage to glass and glazing materials from condensation, temperature changes, direct exposure to sun, or <br />other causes. <br />B. For insulating-glass units that will be exposed to substantial altitude changes, comply with insulating- <br />glass manufacturer's written recommendations for venting and sealing to avoid hermetic seal ruptures. <br />1.8 PROJECT CONDITIONS <br />A. Environmental Limitations: Do not proceed with glazing when ambient and substrate temperature <br />conditions are outside limits permitted by glazing material manufacturers and when glazing channel <br />substrates are wet from rain, frost, condensation, or other causes. <br />1. Do not install liquid glazing sealants when ambient and substrate temperature conditions are <br />outside limits permitted by glazing sealant manufacturer or below 40 deg F. <br />1.9 WARRANTY <br />A. Manufacturer's Special Warranty for Coated-Glass Products: Manufacturer's standard form, made out to <br />Owner and signed by coated-glass manufacturer agreeing to replace coated-glass units that deteriorate as <br />defined in "Definitions" Article, f.o.b. the nearest shipping point to Project site, within specified warranty <br />period indicated below. Manufacturing defects are defined as failure or hermetic seal of air space <br />(beyond that due to glass breakage) as evidenced by intrusion of dirt or moisture, internal condensation or <br />fogging, deterioration of protected internal glass coatings, if any, and other visual indications of seal <br />failure or performance; provided the manufacturer's instructions for handling, installing, protecting and <br />maintaining units have been complied with during the warranty period. Warranty shall be non-prorated. <br />1. Warranty Period: 10 years from date of Substantial Completion. <br />B. Manufacturer's Special Warranty on Insulating Glass: Manufacturer's standard form, made out to Owner <br />and signed by insulating-glass manufacturer agreeing to replace insulating-glass units that deteriorate as <br />defined in "Definitions" Article, f.o.b. the nearest shipping point to Project site, within specified warranty <br />period indicated below. Manufacturing defects are defined as failure or hermetic seal of air space <br />(beyond that due to glass breakage) as evidenced by intrusion of dirt or moisture, internal condensation or <br />fogging, deterioration of protected internal glass coatings, if any, and other visual indications of seal <br />failure or performance; provided the manufacturer's instructions for handling, installing, protecting and <br />maintaining units have been complied with during the warranty period. Warranty shall be non-prorated. <br />1. Warranty Period: 10 years from date of Substantial Completion. <br />DocuSign Envelope ID: ECCAC5A0-6CC8-4B37-8AD3-89D69F0AE1AE