2021-414-E-AMS-Riggs-Harrod Builders, Inc-SHSC Roof & HVAC Replacement

Browse Search

Southern Human Services Center Smith Sinnett /2020072 HVAC and Roof Renovations Orange County,North Carolina BAS DIRECT DIGITAL CONTROL SYSTEM 23 09 02 - 6 3.02 EXAMINATION: A.The project plans shall be thoroughly examined for control device and equipment locations.Any discrepancies,conflicts,or omissions shall be reported to the architect/engineer for resolution before rough-in work is started. B.The contractor shall inspect the site to verify that equipment may be installed as shown.Any discrepancies,conflicts,or omissions shall be reported to the engineer for resolution before rough- in work is started. C.The contractor shall examine the drawings and specifications for other parts of the work.If head room or space conditions appear inadequate-or if any discrepancies occur between the plans and the contractor’s work and the plans and the work of others-the contractor shall report these discrepancies to the engineer and shall obtain written instructions for any changes necessary to accommodate the contractor’s work with the work of others. 3.03 PROTECTION A.The contractor shall protect all work and material from damage by its employees and/or subcontractors and shall be liable for all damage thus caused. B.The contractor shall be responsible for its work and equipment until finally inspected,tested,and accepted. 3.04 COORDINATION A.Site 1.The project coordination between trades is the responsibility of the prime contractor who is the one tier higher contractual partner such as mechanical contractor,general contractor, construction manager,owner or owner’s representative as applicable. 2.The controls contractor shall follow prime contractor’s job schedule and coordinate all project related activities through the prime contractor except otherwise agreed or in minor job site issues.Reasonable judgment shall be applied. 3.Where the work will be installed in close proximity to,or will interfere with,work of other trades,the contractor shall assist in working out space conditions to make a satisfactory adjustment. 4.If the contractor deviates form the job schedule and installs work without coordinating with other trades,so as to cause interference with work of other trades,the contractor shall make the necessary changes to correct the condition without extra charge. 5.Coordinate and schedule work with all other work in the same area,or with work that is dependent upon other work,to facilitate mutual progress. B.Submittals. 1.Refer to the “Submittals”article in Part A,7 of this specification for requirements. C.Test and Balance 1.The contractor shall furnish a single set of all tools necessary to interface to the control system for test and balance purposes. 2.The contractor shall provide training in the use of these tools.This training will be planned for a minimum of 4 hours. D.Coordination with controls specified in other sections or divisions. 1.Other sections and/or divisions of this specification include controls and control devices that are to be part of or interfaced to the control system specified in this section.These controls shall be integrated into the system and coordinated by the contractor as follows: a.All communication media and equipment shall be provided as specified in Part B,2, “Communication”of this specification. b.Each supplier of controls product is responsible for the configuration,programming, startup,and testing of that product to meet the sequences of operation described in this section. c.The Contractor shall coordinate and resolve any incompatibility issues that arise between the control products provided under this section and those provided under other sections or divisions of this specification. DocuSign Envelope ID: 94E7997D-4F29-42F6-A9B4-0A160438D2A6