2021-414-E-AMS-Riggs-Harrod Builders, Inc-SHSC Roof & HVAC Replacement

Browse Search

Southern Human Services Center Smith Sinnett /2020072 HVAC and Roof Renovations Orange County,North Carolina BAS DIRECT DIGITAL CONTROL SYSTEM 23 09 02 - 4 D.Primary Network -Panel to Panel Communication: 1.All Building Controllers shall directly reside on the primary Ethernet network such that communications may be executed directly between Building Controllers,directly between server and Building Controllers on a peer-to-peer basis. 2.Systems that operate via polled response or other types of protocols that rely on a central processor,file server,or similar device to manage panel-to-panel or device-to-device communications shall not be acceptable. 3.All operator interfaces shall have the ability to access all point status and application report data or execute control functions for any and all other devices. Access to data shall be based upon logical identification of building equipment. No hardware or software limits shall be imposed on the number of devices with global access to the network data. 2.04 BUILDING CONTROLLER SOFTWARE A.General 1.Furnish the following applications software to form a complete operating system for building and energy management as described in this specification. 2.The software programs specified in this Section shall be provided as an integral part of Building Controllers and shall not be dependent upon any higher level computer or another controller for execution. 3.All points,panels and programs shall be identified by a 30 character name. All points shall also be identified by a 16 character point descriptor. The same names shall be displayed at both Building Controller and the Operator Interface. 4.All digital points shall have a user defined two-state status indication with 8 characters minimum (e.g.Summer,Enabled,Disabled,Abnormal). 5.Building Controllers shall have the ability to perform energy management routines including but not limited to time of day scheduling,calendar-based scheduling,holiday scheduling, temporary schedule overrides,start stop time optimization,automatic daylight savings time switch over,night setback control,enthalpy switch over,peak demand limiting,temperature- compensated duty cycling,heating /cooling interlock,supply temperature reset,priority load shedding,and power failure restart. 6.The Building Controllers shall have the ability to perform the following pre tested control algorithms: a.Two position control b.Proportional control c.Proportional plus integral control d.Proportional,integral,plus derivative control e.Automatic tuning of control loops f.Model-Free Adaptive Control 7.Each controller shall be provided with an interactive HELP function to assist operators using POTs and remote connected operators. B.User Defined Control Applications 1.Controllers shall be able to execute custom,job-specific processes defined by the user,to automatically perform calculations and special control routines. 2.It shall be possible to use any system measured point data or status,any system calculated data,a result from any process,or any user-defined constant in any controller in the system. 3.Any process shall be able to issue commands to points in any and all other controllers in the system. 4.Processes shall be able to generate operator messages and advisories to other operator I/O devices. A process shall be able to directly send a message to a specified device or cause the execution of a dial-up connection to a remote device such as a printer or pager. 5.Each controller shall support plain language text comment lines in the operating program to allow for quick troubleshooting,documentation,and historical summaries of program development. 6.Controller shall provide a HELP function key,providing enhanced context sensitive on-line help with task oriented information from the user manual. DocuSign Envelope ID: 94E7997D-4F29-42F6-A9B4-0A160438D2A6