2021-414-E-AMS-Riggs-Harrod Builders, Inc-SHSC Roof & HVAC Replacement

Browse Search

SHSC HVAC and Roof Replacement Smith Sinnett / 2020072 Orange County, North Carolina METAL ROOF SYSTEM 07 41 00 - 4 B. Handling: Exercise care in unloading, storing, and erecting wall and roof covering panels to prevent bending, warping, twisting, and surface damage. C. Stack materials on platforms or pallets, covered with tarpaulins or other suitable weathertight ventilated covering. Store metal wall and roof panels so that they will not accumulate water. Do not store panels in contact with other materials that might cause staining, denting, or other surface damage. 1.9 WARRANTY A. Special Project Warranty: Provide written non pro-rated warranty, signed by the Manufacturer of primary roofing materials and his authorized Installer, agreeing to replace/repair defective materials and workmanship. "Defective materials and workmanship" shall be defined to include any portion of the roofing system which leaks during the warranty period. NOTE - this warranty includes any and all insulation, underlayment, flashing, curbs and penetrations on the roof in their entirety which all of which shall be provided and installed by this contractor whether specified in this section or other sections of the specifications. This warranty shall be in addition to and not a limitation of other rights the Owner may have against the Contractor under the Contract Documents. The metal roof system manufacturer’s authorized representative shall inspect the installation and guarantee the metal roof system against leaks for a period of twenty (20) years following final acceptance of the work. Guarantee shall be in writing. Guarantee shall be equal to or exceed Single Source 1 Warranty. Manufacturer representative shall inspect the installation at appropriate stages during the construction as necessary to provide a roof warranty without exceptions or qualifications from the manufacturer. The warranty shall not be limited by wind speeds less than the design wind speed. Jurisdiction for warranty shall be the county in which the building is constructed. 1. Warranty Period: 20 years from the date of substantial completion. B. Finish Warranty: Furnish panel manufacturer's written warranty covering failure of the factory-applied exterior finish on metal wall, roof, flashing and soffit panels within the warranty period. Guarantee shall be in writing. 1. Warranty Period: 20 years from the date of substantial completion. C. Contractor’s 24 month warranty: The contractor shall guarantee the materials and workmanship associated with the roofing, insulation, underlayment, flashing and sheet metal work incidental with the roofing against defects, leaks, and other failures, due to faulty material, workmanship, and/or negligence for a period of twenty-four (24) months following final acceptance of the work. All leaks and damages caused by leaks shall be repaired at the Contractor’s expense. The substitution of an equal or longer term manufacturers warranty in lieu of this requirement is not acceptable. Guarantee shall be in writing and countersigned by the Prime Contractor and the Roofing Subcontractor. The warranty shall not be limited by wind speeds less than the design wind speed. Jurisdiction for warranty shall be the county in which the building is constructed D. Note: all flashings, curbs, trim and other penetrations on the roof shall be provided, installed and fully warranted by the metal roof system manufacturer. PART 2 - PRODUCTS 2.1 ROOF SYSTEMS A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering metal roof, wall or soffit panel systems that may be incorporated in the work include but are not limited to the following: 1. “SuperLok” standing seam roof system by MBCI or equal by but not limited to: a. Overly Manufacturing Company b. ATAS c. Berridge d. McElroy e. Metal Roofing Systems, Inc. DocuSign Envelope ID: 94E7997D-4F29-42F6-A9B4-0A160438D2A6