Orange County NC Website
Browse       Search
Construction Documents <br />20052.02 / Orange County - Justice <br />Facility <br />26 2726 - 3 WIRING DEVICES <br />B.Wall Switches - General Requirements: AC only, quiet operating, general-use snap switches <br />with silver alloy contacts, complying with NEMA WD 1 and NEMA WD 6, and listed as <br />complying with UL 20; types as indicated on the drawings. <br />1.Wiring Provisions: Terminal screws for side wiring and screw actuated binding clamp for <br />back wiring with separate ground terminal screw. <br />C.Standard Wall Switches: Industrial heavy duty grade, 20 A, 120/277 V with standard toggle type <br />switch actuator and maintained contacts; single pole single throw, three way, or four way as <br />indicated on the drawings. <br />2.04 WALL DIMMERS <br />A.Manufacturers: <br />1.Leviton Manufacturing Company, Inc. <br />2.Lutron Electronics Company, Inc. <br />3.Pass & Seymour, a brand of Legrand North America, Inc <br />4.Or approved equal. <br />B.Wall Dimmers - General Requirements: Solid-state with continuous full-range even control <br />following square law dimming curve, integral radio frequency interference filtering, power failure <br />preset memory, air gap switch accessible without removing wall plate, complying with NEMA <br />WD 1 and NEMA WD 6, and listed as complying with UL 1472; types and ratings suitable for <br />load controlled as indicated on the drawings. <br />C. Provide accessory wall switches to match dimmer appearance when installed adjacent to each <br />other. <br />D. Contractor shall ensure dimmer switch compatibility with luminaire controlled prior to ordering. <br />2.05 RECEPTACLES <br />A. Manufacturers: <br />1. Hubbell Incorporated. <br />2. Leviton Manufacturing Company, Inc. <br />3. Pass & Seymour, a brand of Legrand North America, Inc. <br />4. Approved equal. <br />5. Source Limitations: Where wall controls are furnished as part of lighting control system, <br />provide accessory matching receptacles and wallplates by the same manufacturer in <br />locations indicated. <br />B. Receptacles - General Requirements: Self-grounding, complying with NEMA WD 1 and NEMA <br />WD 6, and listed as complying with UL 498, and where applicable, FS W-C-596; types as <br />indicated on the drawings. <br />1. Wiring Provisions: Terminal screws for side wiring or screw actuated binding clamp for <br />back wiring with separate ground terminal screw. <br />2. NEMA configurations specified are according to NEMA WD 6. <br />C. Convenience Receptacles: <br />1. Standard Convenience Receptacles: Industrial Heavy Duty Grade, 20A, 125V, NEMA <br />5-20R; single or duplex as indicated on the drawings. <br />D. GFCI Receptacles: <br />1. GFCI Receptacles - General Requirements: Self-testing, with feed-through protection and <br />light to indicate ground fault tripped condition and loss of protection; listed as complying <br />with UL 943, class A. <br />a. Provide test and reset buttons of same color as device. <br />2. Standard GFCI Receptacles: Extra Heavy Duty Grade, duplex, 20A, 125V, NEMA 5-20R, <br />rectangular decorator style. <br />3. Weather Resistant GFCI Receptacles: Commercial specification grade, duplex, 20A, <br />125V, NEMA 5-20R, rectangular decorator style, listed and labeled as weather resistant <br />type complying with UL 498 Supplement SE suitable for installation in damp or wet <br />locations. <br />DocuSign Envelope ID: 09980A3B-0691-41B4-854D-3865F2287392