Orange County NC Website
Browse       Search
Orange County Facility Renovations <br />Hillsborough, NC <br />Smith Sinnett ROLLER WINDOW SHADES <br />2020046/2020047/2020048/2020049/2020055 12 24 13 - 3 <br />4. Recessed Shade Pocket: Rectangular, extruded-aluminum enclosure designed for recessed ceiling <br />installation; with front, top, and back formed as one piece, end plates, and removable bottom <br />closure panel. <br />2.3 SHADEBAND MATERIALS <br />A. Shadeband Material Flame-Resistance Rating: Comply with NFPA 701. Testing by a qualified testing <br />agency. Identify products with appropriate markings of applicable testing agency. <br />B. Light-Filtering Fabric: Woven fabric, stain and fade resistant. <br />1. Openness Factor: 5 percent <br />2. Color: As selected by Architect from manufacturer's full range. <br />2.4 ROLLER SHADE FABRICATION <br />A. Product Safety Standard: Fabricate roller shades to comply with WCMA A 100.1 <br />B. Unit Sizes: Fabricate units in sizes to fill window and other openings as follows, measured at 74 deg F: <br />1. Between (Inside) Jamb Installation: Width equal to jamb-to-jamb dimension of opening in which <br />shade is installed less 1/4 inch per side or 1/2-inch total, plus or minus 1/8 inch. Length equal to <br />head-to-sill or -floor dimension of opening in which shade is installed less 1/4 inch, plus or minus <br />1/8 inch. <br />2. Outside of Jamb Installation: Width and length as indicated, with terminations between shades of <br />end-to-end installations at centerlines of mullion or other defined vertical separations between <br />openings. <br />C. Shadeband Fabrication: Fabricate shadebands without battens or seams to extent possible, except as <br />follows: <br />1. Vertical Shades: Where width-to-length ratio of shadeband is equal to or greater than 1:4, provide <br />battens and seams at uniform spacings along shadeband length to ensure shadeband tracking and <br />alignment through its full range of movement without distortion of the material. <br />PART 3 - EXECUTION <br />3.1 ROLLER SHADE INSTALLATION <br />A. Install roller shades level, plumb, and aligned with adjacent units according to manufacturer's written <br />instructions. <br />B. Adjust and balance roller shades to operate smoothly, easily, safely, and free from binding or malfunction <br />throughout entire operational range. <br />C. Clean roller shade surfaces, after installation, according to manufacturer's written instructions. <br />D. Replace damaged roller shades that cannot be repaired, in a manner approved by Architect, before time of <br />Substantial Completion. <br />END OF SECTION <br />DocuSign Envelope ID: 09980A3B-0691-41B4-854D-3865F2287392