Orange County NC Website
Browse       Search
ORANGE COUNTY FACILITY RENOVATIONS <br /> <br /> <br />DOOR HARDWARE 087100-13 <br /> 12/21/2020 <br /> <br />allow sequencing operation of two units, and SPDT relay for interfacing with latching or <br />locking devices. <br />2.12 DOOR TRIM <br />A. Manufacturers: <br />1. Scheduled Manufacturer: Ives. <br />2. Acceptable Manufacturers: Burns, Hiawatha. <br />B. Requirements: <br />1. Provide push plates 4 inches (102 mm) wide by 16 inches (406 mm) high by 0.050 inch <br />(1 mm) thick and beveled 4 edges. Where width of door stile prevents use of 4 inches <br />(102 mm) wide plate, adjust width to fit. <br />2. Provide push bars of solid bar stock, diameter and length as scheduled. Provide push <br />bars of sufficient length to span from center to center of each stile. Where required, <br />mount back to back with pull. <br />3. Provide offset pulls of solid bar stock, diameter and length as scheduled. Where required, <br />mount back to back with push bar. <br />4. Provide pulls of solid bar stock, diameter and length as scheduled. Where required, <br />mount back to back with push bar. <br />5. Provide pull plates 4 inches (102 mm) wide by 16 inches (406 mm) high by 0.050 inch (1 <br />mm) thick, beveled 4 edges, and prepped for pull. Where width of door stile prevents use <br />of 4 inches (102 mm) wide plate, adjust width to fit. <br />2.13 PROTECTION PLATES <br />A. Manufacturers: <br />1. Scheduled Manufacturer: Ives. <br />2. Acceptable Manufacturers: Burns, Hiawatha. <br />B. Requirements: <br />1. Provide kick plates, mop plates, and armor plates minimum of 0.050 inch (1 mm) thick, <br />beveled four edges as scheduled. Furnish with sheet metal or wood screws, finished to <br />match plates. <br />2. Sizes of plates: <br />a. Kick Plates: 10 inches (254 mm) high by 2 inches (51 mm) less width of door on <br />single doors, 1 inch (25 mm) less width of door on pairs <br />2.14 OVERHEAD STOPS AND OVERHEAD STOP/HOLDERS <br />A. Manufacturers: <br />1. Scheduled Manufacturers: Glynn-Johnson. <br />2. Acceptable Manufacturers: Rixson, ABH. <br />B. Requirements: <br />DocuSign Envelope ID: 09980A3B-0691-41B4-854D-3865F2287392