Orange County NC Website
Browse       Search
Orange County Facility Renovations <br />Hillsborough, NC <br />Smith Sinnett EXECUTION <br />2020046/2020047/2020048/2020049/2020055 01 73 00 - 5 <br />B.Comply with manufacturer's written instructions and recommendations for installing products in <br />applications indicated. <br />C.Install products at the time and under conditions that will ensure satisfactory results as judged by <br />Architect. Maintain conditions required for product performance until Substantial Completion. <br />D.Conduct construction operations, so no part of the Work is subjected to damaging operations or loading in <br />excess of that expected during normal conditions of occupancy of type expected for Project. <br />E.Sequence the Work and allow adequate clearances to accommodate movement of construction items on- <br />site and placement in permanent locations. <br />F.Tools and Equipment: Select tools or equipment that minimize production of excessive noise levels. <br />G.Templates: Obtain and distribute to the parties involved templates for Work specified to be factory <br />prepared and field installed. Check Shop Drawings of other portions of the Work to confirm that adequate <br />provisions are made for locating and installing products to comply with indicated requirements. <br />H.Attachment: Provide blocking and attachment plates and anchors and fasteners of adequate size and <br />number to securely anchor each component in place, accurately located and aligned with other portions of <br />the Work. Where size and type of attachments are not indicated, verify size and type required for load <br />conditions with manufacturer. <br />1.Mounting Heights: Where mounting heights are not indicated, mount components at heights <br />directed by Architect. <br />2.Allow for building movement, including thermal expansion and contraction. <br />3.Coordinate installation of anchorages. Furnish setting drawings, templates, and directions for <br />installing anchorages, including sleeves, concrete inserts, anchor bolts, and items with integral <br />anchors, that are to be embedded in concrete or masonry. Deliver such items to Project site in time <br />for installation. <br />I.Joints: Make joints of uniform width. Where joint locations in exposed Work are not indicated, arrange <br />joints for the best visual effect, as judged by Architect. Fit exposed connections together to form hairline <br />joints. <br />J.Repair or remove and replace damaged, defective, or nonconforming Work. <br />1.Comply with Section 01 77 00 "Closeout Procedures" for repairing or removing and replacing <br />defective Work. <br />3.6 CUTTING AND PATCHING <br />A.General: Employ skilled workers to perform cutting and patching. Proceed with cutting and patching at <br />the earliest feasible time, and complete without delay. <br />1.Cut in-place construction to provide for installation of other components or performance of other <br />construction, and subsequently patch as required to restore surfaces to their original condition. <br />B.Existing Warranties: Remove, replace, patch, and repair materials and surfaces cut or damaged during <br />installation or cutting and patching operations, by methods and with materials so as not to void existing <br />warranties. <br />C.Temporary Support: Provide temporary support of Work to be cut. <br />DocuSign Envelope ID: 09980A3B-0691-41B4-854D-3865F2287392