Orange County NC Website
Browse       Search
DocuSign Envelope ID:D561B1AE-DF34-4907-AD06-AOEB37BBE427 <br /> CHAPEL HILL ORANGE COUNTY VISITORS BUREAU August 12,2020 <br /> 308 WEST FRANKLIN,CHAPEL HILL,NC <br /> F. Anchor woodwork to anchors or blocking built in or directly attached to substrates. Secure with <br /> countersunk, concealed fasteners and blind nailing as required for complete installation. Use <br /> fine finishing nails[or finishing screws] for exposed fastening, countersunk and filled flush with <br /> woodwork and matching final finish if transparent finish is indicated. <br /> G. Standing and Running Trim: Install with minimum number of joints possible, using full-length <br /> pieces (from maximum length of lumber available) to greatest extent possible. Do not use <br /> pieces less than 72 inches long, except where shorter single-length pieces are necessary. Scarf <br /> running joints and stagger in adjacent and related members. <br /> 1. Fill gaps, if any, between top of base and wall with plastic wood filler, sand smooth, and <br /> finish same as wood base if finished. <br /> 2. Install wall railings on indicated metal brackets securely fastened to wall framing. <br /> 3. Install standing and running trim with no more variation from a straight line than 1/8 inch <br /> in 96 inches(3 mm in 2400 mm). <br /> H. Paneling: Anchor paneling to supporting substrate with concealed panel-hanger clips splined <br /> connection strips. Do not use face fastening,unless otherwise indicated. <br /> 1. Install flush paneling with no more than 1/16 inch in 96-inch (1.5 mm in 2400-mm) <br /> vertical cup or bow and 1/8 inch in 96-inch(3 mm in 2400-mm)horizontal variation from <br /> a true plane. <br /> I. Cabinets: Install without distortion so doors and drawers fit openings properly and are accurately <br /> aligned. Adjust hardware to center doors and drawers in openings and to provide <br /> unencumbered operation. Complete installation of hardware and accessory items as indicated. <br /> 1. Install cabinets with no more than 1/8 inch in 96-inch (3 mm in 2400-mm) sag, bow, or <br /> other variation from a straight line. <br /> 2. Maintain veneer sequence matching of cabinets with transparent finish. <br /> 3. Fasten wall cabinets through back, near top and bottom, at ends and not more than 16 <br /> inches (400 mm) o.c. with No. 10 wafer-head sheet metal screws through metal backing <br /> or metal framing behind wall finish or toggle bolts through metal backing or metal <br /> framing behind wall finish <br /> J. Countertops: Anchor securely by screwing through corner blocks of base cabinets or other <br /> supports into underside of countertop. Follow manufacturers instructions for concrete and <br /> glass,concrete and stone and glass countertops. <br /> 1. Install countertops with no more than 1/8 inch in 96-inch (3 mm in 2400-mm) sag, bow, <br /> or other variation from a straight line. <br /> 2. Secure backsplashes to walls with adhesive. <br /> 3. Calk space between backsplash and wall with sealant specified in Division 07 Section <br /> "Joint Sealants." <br /> K. Touch up finishing work specified in this Section after installation of woodwork. Fill nail holes <br /> with matching filler where exposed. <br /> L. Refer to Division 09 Sections for final finishing of installed architectural woodwork not indicated <br /> to be shop finished. <br /> INTERIOR ARCHITECTURAL WOODWORK 064023 - 12 <br />