Orange County NC Website
Browse       Search
DocuSign Envelope ID:D561B1AE-DF34-4907-AD06-AOEB37BBE427 <br /> CHAPEL HILL ORANGE COUNTY VISITORS BUREAU August 12,2020 <br /> 308 WEST FRANKLIN,CHAPEL HILL,NC <br /> B. Manufacturers: <br /> 1. Baldwin Hardware Corporation(BH). <br /> 2. Bommer Industries, Inc. (BI). <br /> 3. Cal-Royal Products, Inc. (CRP). <br /> 4. Hager Companies(HAG). <br /> 5. Lawrence Brothers,Inc. (LB). <br /> 6. McKinney Products Company; an ASSA ABLOY Group company(MCK). <br /> 7. PBB, Inc. (PBB). <br /> 8. Stanley Commercial Hardware; Div. of The Stanley Works(STH). <br /> 9. Others specifically named in Hardware Schedule. <br /> 2.5 LOCKS AND LATCHES,GENERAL <br /> A. Accessibility Requirements: Where indicated to comply with accessibility requirements, comply with <br /> the U.S. Architectural & Transportation Barriers Compliance Board's "Americans with Disabilities Act <br /> (ADA),Accessibility Guidelines for Buildings and Facilities (ADAAG)." And ANSI A117.1. <br /> 1. Provide lever operating devices that do not require tight grasping, pinching, or twisting of the <br /> wrist and that operate with a force of not more than 5 lbf(22 N). <br /> B. Latches and Locks for Means of Egress Doors: Comply with NFPA 101. Latches shall not require <br /> more than 15 lbf (67 N) to release the latch. Locks shall not require use of a key, tool, or special <br /> knowledge for operation. <br /> C. Lock Trim: <br /> 1. Levers: as scheduled. <br /> 2. Escutcheons (Roses): as scheduled. <br /> 3. Dummy Trim: Match trim and escutcheons. <br /> 4. Lockset Designs: Provide design indicated in hardware sets or, if sets are provided by another <br /> manufacturer,provide designs that match those designated. <br /> D. Lock Throw: Comply with testing requirements for length of bolts required for labeled fire doors, and <br /> as follows: <br /> 1. Bored Locks: Minimum 1/2-inch(13-mm)latchbolt throw. <br /> 2. Mortise Locks: Minimum 3/4-inch(19-mm) latchbolt throw. <br /> 3. Deadbolts: Minimum 1-inch(25-mm)bolt throw. <br /> E. Rabbeted Meeting Doors: Provide special rabbeted front and strike on locksets for rabbeted meeting <br /> stiles. <br /> F. Backset: 2-3/4 inches (70 mm),unless otherwise indicated. <br /> G. Strikes: Manufacturer's standard strike with strike box for each latchbolt or lock bolt, with curved lip <br /> extended to protect frame, finished to match door hardware set, and as follows: <br /> 1. Strikes for Bored Locks and Latches: BHMA A156.2. <br /> DOOR HARDWARE 087100 -7 <br />