Orange County NC Website
Browse       Search
DocuSign Envelope ID:D561B1AE-DF34-4907-AD06-AOEB37BBE427 <br /> CHAPEL HILL ORANGE COUNTY VISITORS BUREAU August 12,2020 <br /> 308 WEST FRANKLIN,CHAPEL HILL,NC <br /> 3.2 INSTALLATION <br /> A. Hardware: For installation, see Division 08 Section"Door Hardware." <br /> B. Installation Instructions: Install doors to comply with manufacturer's written instructions and <br /> the referenced quality standard, and as indicated. <br /> 1. Install fire-rated doors in corresponding fire-rated frames according to NFPA 80. <br /> C. Job-Fitted Doors: Align and fit doors in frames with uniform clearances and bevels as indicated <br /> below; do not trim stiles and rails in excess of limits set by manufacturer or permitted for fire- <br /> rated doors. Machine doors for hardware. Seal edges of doors, edges of cutouts, and mortises <br /> after fitting and machining. <br /> 1. Clearances: Provide 1/8 inch (3.2 mm) at heads, jambs, and between pairs of doors. <br /> Provide 1 inch from bottom of door to top of decorative floor finish or covering unless <br /> otherwise indicated. Where threshold is shown or scheduled, provide 1 inch (6.4 mm) <br /> from bottom of door to top of threshold unless otherwise indicated. <br /> 2. Bevel non-fire-rated doors 1/8 inch in 2 inches(3-1/2 degrees) at lock and hinge edges. <br /> D. Factory-Fitted Doors: Align in frames for uniform clearance at each edge. <br /> E. Factory-Finished Doors: Restore finish before installation if fitting or machining is required at <br /> Project site. <br /> 3.3 ADJUSTING <br /> A. Operation: Rehang or replace doors that do not swing or operate freely. <br /> B. Finished Doors: Replace doors that are damaged or that do not comply with requirements. <br /> Doors may be repaired or refinished if work complies with requirements and shows no evidence <br /> of repair or refinishing. <br /> END OF SECTION 081416 <br /> WOOD DOORS 081416 - 6 <br />