Orange County NC Website
Browse       Search
DocuSign Envelope ID:A18808EO-5F70-4494-BCOC-49B95D82162D <br /> Page 12 <br /> Each Item Detailed Specification <br /> 5 Lighting, task, over Provide task lights at each counter top location where <br /> counter overhead cabinets allow. Each built-in, flush mounted, 115- <br /> volt fluorescent task shall have a switch. A light intensity of <br /> 70 foot-candles minimum (with task light on)shall be required <br /> at each workstation. <br /> 1 Lighting, undercarriage Each stowage compartment shall be provided with a 12-volt <br /> compartments lighting fixture. Lamps shall be provided with guards. <br /> Lighting fixtures shall be protected, water-resistant, and <br /> readily accessible for servicing. Bulbs shall be capable of <br /> being replaced without removing fixtures. A 10-minute timer <br /> switch shall be provided. The timer switch shall control all 12- <br /> volt stowage compartment lighting. <br /> 1 Manual, operating Full set of operating manuals for every major component on <br /> the van. <br /> 1 Receptacle, 110 vac, At least two 110 vac receptacles, with complete weather <br /> exterior protection, mounted undercarriage. Department to specify <br /> location. <br /> 1 Rooms built with Interior wall construction shall be custom-formed panels <br /> interlocking panels sandwiched between a 14 gauge extruded aluminum. <br /> Straight walls, without curved ceiling-wall junctions, must be <br /> provided to provide specified headroom. The wall panels <br /> shall be constructed of either .075 inch fiberglass reinforced <br /> plastic laminated to both sides of a 1 inch thick closed-cell <br /> expanded polystyrene foam substrate, or 3mm expanded <br /> PVC, laminated to both sides of a 5/8 inch CFC-free urethane <br /> foam substrate. The wall panels shall be held in place by a <br /> two-piece (base and trim) division bar system. The wall <br /> panels must be easily removable without cutting or damaging <br /> the panel. The system shall be designed so that no rivets, <br /> screws or fasteners shall be visible. The division bars shall <br /> be oriented vertically and spaced to support cabinets, doors <br /> and windows. An aluminum channel base shall be furnished <br /> to protect the wall panels. The wall panels shall have a matte <br /> finish; a gloss finish is not acceptable. <br /> 5 Seat, chair securement Wall-mounted chair hold down to secure chairs when vehicle <br /> system is in transit. <br /> 1 Seat, drafting Chair to have commercial-grade vinyl padded seat, contoured <br /> back with lumbar support, pneumatic seat height adjustment, <br /> adjustable chrome footing, back height and depth adjustment, <br /> reinforced molded base, heavy-duty dual wheel casters for <br /> easy mobility. <br /> 2 Seat, flip-up, vinyl or Color/upholstery choices by Department, fully seat belted to <br /> fabric, single FMVS standards, floor mounted, sprung to store in upright <br /> position. Single seat (each 18"x 12" x 31") required. <br /> Department to select covering for seat(s)from either vinyl or <br /> cloth selections. <br /> 1 Shore power cord, 75 ft. 80 ampere, single phase, main shore power cable shall be <br /> provided with 100 amp rated connectors to power all rear <br /> cabin equipment. The electrical system shall be GFCI <br /> protected at every receptacle within 6 feet of a water source. <br /> Two shore power receptacles shall be provided in the storage <br /> compartment to select generator or shore power. A weather- <br /> resistant receptacle and plug on each end of the shore power <br /> cable shall be furnished. The cable shall be rated SO by the <br />