Orange County NC Website
Browse       Search
DocuSign Envelope ID:49B6796B-1634-4210-BE70-3ADC8E4BA5D3 <br /> SIMME-SEA T GENERAL INSTALLATION INSTRUCTIONS <br /> 1. For Simme—Seat installation on on existing sidewalk or other <br /> portland cement concrete paving with a minimum thickness of 4 <br /> inches, skip to step 3. <br /> 2. For Simme—Seat installation adjacent to existing concrete or at <br /> an isolated position away from concrete paving, refer to Figure E <br /> 1, Foundation Installation Instructions, before proceeding with <br /> step J. <br /> J. With the Simme—Seat support boseplote as template, mark the <br /> expansion anchor locations and use on impact drill motor and <br /> 7/8—inch masonry bit to drill four 2-112 inch deep holes in the <br /> concrete sidewalk or prepared foundation. <br /> 4. Insert the four provided expansion anchors into the drilled holes <br /> and complete their installation according to Figure 2, Anchor <br /> Installation Instructions. <br /> 5. Position the Simme--Seat support in place over the expansion <br /> anchors, shim as required to level, and secure with four machine <br /> bolts and flat washers provided. (Refer to Figute 3, Support <br /> Installation) <br /> 6. Attach the two seat sections to the Simme—Seat support <br /> gusset plates with JIB—inch bolts and lock nuts provided. <br /> (Refer to Figure 4, Seat Assembly) <br /> 7. Insert bus stop sign post into the Simme—Seat base support <br /> tube, and mark the sign post at the top of the base support <br /> tube and at the locations of the two holes in the support tube <br /> where the securing thru—bolt connection will be made. <br /> B. Remove the sign post from the base support tube and drill two <br /> 3/S" holes at the marked locations for the thru—bolt <br /> connection. <br /> 9. Remove the backing paper from the provided I " wide x 7- 114" <br /> long piece of 3M UHMW polyethylene tape and wrap the tape <br /> around the sign post, centered at the previously marked <br /> location at the top of the support tube. Install the provided <br /> finial on top of the sign post, reinsert the sign post into the <br /> base support tube, and secure the sign post in place with the <br /> 5116" x 3- 1/2" bolt, flat washer and lock nut provided. (Refer <br /> to Figure 5, Sign Post Installation) <br /> 2 <br />