Orange County NC Website
Browse       Search
DocuSign Envelope ID: B94F2D40-3B3C-47A7-86C2-6F1 B4F92C62C <br /> SECTION 01 33 00-SUBMITTAL PROCEDURES <br /> c. Manufacturer's installation instructions. <br /> d. Standard color charts. <br /> e. Manufacturer's catalog cuts. <br /> f. Wiring diagrams showing factory-installed wiring. <br /> g. Printed performance curves. <br /> h. Operational range diagrams. <br /> i. Mill reports. <br /> j. Standard product operating and maintenance manuals. <br /> k. Compliance with recognized trade association standards. <br /> I. Compliance with recognized testing agency standards. <br /> m. Application of testing agency labels and seals. <br /> n. Notation of coordination requirements. <br /> C. Shop Drawings: Prepare Project-specific information, drawn accurately to scale. Do not base Shop Drawings on <br /> reproductions of the Contract Documents or standard printed data. <br /> 1. Preparation: Include the following information, as applicable: <br /> a. Dimensions. <br /> b. Identification of products. <br /> c. Identification of finishes. <br /> d. Identification of fasteners. <br /> e. Fabrication and installation drawings. <br /> f. Roughing-in and setting diagrams. <br /> g. Wiring diagrams showing field-installed wiring, including power, signal, and control wiring. <br /> h. Shopwork manufacturing instructions. <br /> i. Templates and patterns. <br /> j. Schedules. <br /> k. Design calculations. <br /> I. Compliance with specified standards. <br /> m. Notation of coordination requirements. <br /> n. Notation of dimensions established by field measurement. <br /> 2. Wiring Diagrams: Differentiate between manufacturer-installed and field-installed wiring. <br /> 3. Number of Copies: Submit each submittal in electronic format. <br /> D. Samples: Prepare physical units of materials or products, including the following: <br /> 1. Comply with requirements in Division 01, Section"Quality Requirements"for mockups. <br /> 2. Samples for Initial Selection: If colors, textures, and patterns are not pre-selected, submit manufacturer's color <br /> charts consisting of units or sections of units showing the full range of colors,textures, and patterns available. <br /> 3. Samples for Verification: Submit full-size units or Samples of size indicated, prepared from the same material <br /> to be used for the Work, cured and finished in manner specified, and physically identical with the product <br /> proposed for use, and that show full range of color and texture variations expected. Samples include, but are <br /> not limited to, the following: partial sections of manufactured or fabricated components; small cuts or <br /> containers of materials; complete units of repetitively used materials; swatches showing color, texture, and <br /> pattern; color range sets; and components used for independent testing and inspection. <br /> a. Color samples are to be submitted in a complete package. <br /> 4. Preparation: Mount, display, or package Samples in manner specified to facilitate review of qualities indicated. <br /> Prepare Samples to match Architect's sample where so indicated. Attach label on unexposed side that <br /> includes the following: <br /> a. Generic description of Sample. <br /> b. Product name or name of manufacturer. <br /> c. Sample source. <br /> 5. Submit Samples for review of kind, color, pattern, and texture for a final check of these characteristics with <br /> other elements and for a comparison of these characteristics between final submittal and actual component as <br /> delivered and installed. <br /> a. If variation in color, pattern, texture, or other characteristic is inherent in the product represented by a <br /> Sample, submit at least three sets of paired units that show approximate limits of the variations. <br /> ©BOOMERANG DESIGN#1835 01 33 00-3 510 Meadowlands Drive,Hillsborough, NC <br /> ORANGE COUNTY,NC 12/07/2018 <br />