Orange County NC Website
Browse       Search
• e <br />MM <br />AgaIlk <br />IMPS Comprehensive Review of <br />Solid Waste Collection and Disposal Options <br />Modular combustion units offer a lower capital cost and simplicity than the larger field - erected <br />mass- burning systems for communities considering WTE systems. These systems are generally <br />reliable and are backed by many years of successful operating experience. The newer batch <br />oxidation systems (BOS) appear to offer substantially lower costs of operations and <br />maintenance. For example, the manpower required to operate these systems is generally <br />minimal with one worker required to load the primary chamber and discharge the ash stream <br />within an hour. Many suppliers claim nearly complete burn out between energy recovery and <br />recycling. The ash remaining is reported to be about 3 to 8% of the original volume (depending <br />on waste composition). Lastly, these systems are modular and can be easily increased or <br />decreased iu"l size. <br />Based on our experience with similar modular plants, SCS would anticipate that an experienced <br />staff of six (6) to nine (9) people, spread over three shifts per day, is required to continuously <br />operate a plant of the size potentially applicable to the Town or region. <br />12.3.4 Refuse - Derived fuel Systems <br />Several American corporations have developed technologies that pre - process solid waste to <br />varying degrees to separate the non - combustibles from the waste stream. By undergoing <br />processing steps of hammering, shredding, or hydropulping, the combustible fraction of the <br />waste is transformed into a fuel, which can then be fired in a boiler unit specifically dedicated for <br />this type of refuse - derived fuel (RDF), or co -fired with another fuel, such as coal, shredded tires, <br />or wood chips. The fuel produced can thus be utilized in equipment that can have higher <br />efficiencies than mass -fired units resulting in greater electricity or steam output. However, the <br />front -end processing of the solid waste into a fuel has been one of the problem areas of this type <br />of refuse disposal technology. <br />Since the early 1970's, there have been several dozen facilities which have been constructed in <br />the United States to process solid waste into a RDF through the use of dry processing systems. <br />Such dry processing systems are classified according to the type of products that call be <br />produced; fluff RDF, densified RDF, and powdered RDF. A cross- section of a typical RDF <br />system is illustrated in Exhibit 12 -5. <br />v2.1 164 14/22/12 <br />