2018-425-E AMS - Sasser Companies Annex upfit

Browse Search

DocuSign Envelope ID: 9826C043- 4C32- 49CD- A4CC- DC28ABAB7CE7 SECTION 236000 - COMMON WORK RESULTS FOR HVAC Any conflicts corrected by relocation or elevation changes do not constitute extra work. 3.9 INCIDENTAL CONSTRUCTION WORK A. All blocking for openings for piping in concrete floors, masonry walls or partitions shall be provided by this Contractor. 1. This Contractor shall do all cutting and fitting of his work and of other work that may be required to make the several parts come together properly and to fit his work to receive or be received by the work of other Contractors as shown upon, or reasonably implied by the drawings and specifications. 2. He shall properly complete and finish up his work after other Contractors have finished as the Designer may direct. B. All excavating required for the installation of this system shall be done by this Contractor. 1. Backfill shall be accomplished as specified in appropriate section of specifications. C. Chases are prohibited in masonry walls which are not to be plastered or paneled. 1. Set piping, blocking, carriers, etc. indicated to be concealed before walls are constructed in order that walls may be constructed around them. 2. This Contractor shall furnish all sleeves in floors, beams, walls, etc., for each such penetration as needed for installing his work and installation of sleeves by General Contractor. D. Unless otherwise noted, the General Contractor will provide openings and lintels as new construction progresses, but this Contractor shall fully designate his requirements prior to construction. 1. Failure to furnish his requirements prior to building construction and failure to coordinate his work with the building construction shall make this Contractor responsible for removing, replacing and painting building construction as required for installation of his work. 3.10 ACCESS DOORS A. Provide and install access doors in walls, ceilings, etc. as required for access to valves, dampers, fire dampers, controls, and other devices requiring access in ceilings, chases, soffits, etc. B. Access doors in non -fire rated walls or ceilings shall be as follows: 1. Nominal 24" x 24" minimum size. 2. 16 -gage steel frame with 14 -gage door panel and galvanized steel drywall bead. 3. Flush style with provision to conceal flange with drywall cement. 4. Double- acting concealed spring hinges to allow opening to 175 degrees. 5. Flush, Allen -head operated with steel cam. 6. Gray prime - painted steel, for painting to match adjacent finished surfaces. 7. Basis of Design: Milcor Style DW; Comparable Products by Karp, Elmdor, Acudor. C. Access doors in fire -rated walls or ceilings shall be as follows: 1. Nominal 24" x 24" minimum size. 2. UL 1 -1/2 hour, Class B fire rating. 3. Prime - painted stainless steel: 16 -gage frame with 20 -gage door panel, for painting to match adjacent finished surfaces. 4. 2" mineral fiber insulation between inner and outer panel. 5. Continuous hinge, steel with stainless steel pin. 6. Self- closing and self - latching panel closer. 7. Flush mounted paddle latch and locking system with flush, key- operated cylinder lock with two keys. 8. Basis of Design: Milcor Style UFR; Comparable Products by Karp, Elmdor, Acudor. 3.11 SUPERVISION A. This Contractor shall have in charge of the work at all times during construction a thoroughly competent foreman with extensive experience in the work to be performed under this contract. 1. Anyone deemed not capable by the Designer shall be replaced immediately upon request, and after satisfactory foreman has been assigned, he shall not be withdrawn without the written consent of the Designer. Reece, Noland & McElrath, Inc. 236000-4 Orange County Board of Elections Orange Co., NC 05/04/18