Orange County NC Website
Article 7: Subdivisions <br />Section 7.8:Access and Roadways <br />(ii)Culverts shall be kept clear of trash and other obstructions that <br />could prevent or reduce the culverts function. If culverts are not <br />kept clear it will cause runoff to flow over the road and may <br />cause flooding upstream. Ditch banks and bottoms shall be <br />protected from erosion by maintaining good vegetation. <br />(iii)The travelway shall be maintained by grading the surface <br />material to fill any potholes that develop and to evenly spread the <br />surface material where the soil has been uncovered because of <br />erosion. <br />(iv)The road name sign shall be kept visible and legible so that <br />visitors and emergency personnel can easily locate the road. <br />(15)Vertical Clearance <br />A minimum 14-foot vertical clearance shall be provided above the travelway to <br />permit the passage of large vehicles under power lines and tree limbs. <br />(16)N.C. Department of Transportation Driveway Permit <br />The property owner is responsible for obtaining the required permit for access to <br />the state maintained road. This permit can be obtained from the DOT in <br />Hillsborough. Permits are normally granted on request. <br />(17)Minimum Curve Radius <br />(a)New curves shall be constructed with a minimum centerline radius of <br />125-feet (see graphic). <br />Figure 7.8.5.D.17.a: Minimum Curve Radius <br />(b)The right-of-way shall be designed with bends that will provide sufficient <br />width to construct the road to the minimum radius. For example, a 90 <br />degree bend in a 50-foot right-of-way will not provide enough area to <br />construct a road 18-feet wide. <br />(c)The right-of-way must include sufficient width for the travelway and the <br />necessary shoulders, ditches and slopes. <br />(d)A curve radius of less than 125-feet may be approved if all of the <br />following conditions are met: <br />Orange County, North Carolina – Unified Development Ordinance Page 7-25 <br />35 <br />ReturntoAgenda