Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />3.1 EXAMINATION <br />A. Examine substrates, areas, and conditions, with Installer present, for compliance with <br />requirements for installation tolerances and other conditions affecting performance of work. <br />B. Verify that items, including anchor inserts, are sized and located to accommodate signs. <br />C. Proceed with installation only after unsatisfactory conditions have been corrected. <br />3.2 INSTALLATION <br />A. Locate signs and accessories where indicated, using mounting methods of types described and <br />complying with manufacturer's written instructions. <br />1. Install signs level, plumb, and at heights indicated, with sign surfaces free of distortion <br />and other defects in appearance. <br />2. Interior Wall Signs: Install signs on walls adjacent to latch side of door where applicable. <br />Where not indicated or possible, such as double doors, install signs on nearest adjacent <br />walls. Locate to allow approach within 3 inches (75 mm) of sign without encountering <br />protruding objects or standing within swing of door. <br />B. Wall- Mounted Signs: Comply with sign manufacturer's written instructions except where more <br />stringent requirements apply. <br />1. Two -Face Tape: Mount signs to smooth, nonporous surfaces. Do not use this method for <br />vinyl- covered or rough surfaces. <br />2. Silicone - Adhesive Mounting: Attach signs to irregular, porous, or vinyl- covered <br />surfaces. <br />3. Shim Plate Mounting: Provide 1/8 -inch- (3 -mm -) thick, concealed aluminum shim plates <br />with predrilled and countersunk holes, at locations indicated, and where other mounting <br />methods are not practicable. Attach plate with fasteners and anchors suitable for secure <br />attachment to substrate. Attach panel signs to plate using method specified above. <br />4. Signs Mounted on Glass: Provide matching opaque plate on opposite side of glass to <br />conceal mounting materials. <br />3.3 CLEANING AND PROTECTION <br />A. After installation, clean soiled sign surfaces according to manufacturer's written instructions. <br />Protect signs from damage until acceptance by Owner. <br />END OF SECTION 104313 <br />SIGNAGE 104313-6 <br />