Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />g jpi� 9:4 91 7:3 7: � 0[ to] i <br />A. General: Comply with CRI 104, Section 6.2, "Site Conditions; Floor Preparation," and with <br />carpet tile manufacturer's written installation instructions for preparing substrates indicated to <br />receive carpet tile installation. <br />B. Use trowelable leveling and patching compounds, according to manufacturer's written <br />instructions, to fill cracks, holes, depressions, and protrusions in substrates. Fill or level cracks, <br />holes and depressions 1/8 inch (3 mm) wide or wider and protrusions more than 1/32 inch (0.8 <br />mm), unless more stringent requirements are required by manufacturer's written instructions. <br />C. Remove coatings, including curing compounds, and other substances that are incompatible with <br />adhesives and that contain soap, wax, oil, or silicone, without using solvents. Use mechanical <br />methods recommended in writing by carpet tile manufacturer. <br />D. Broom and vacuum clean substrates to be covered immediately before installing carpet tile. <br />3.3 INSTALLATION <br />A. General: Comply with CRI 104, Section 14, "Carpet Modules," and with carpet tile <br />manufacturer's written installation instructions. <br />B. Installation Method: Glue down; install every tile with full- spread, releasable, pressure - <br />sensitive adhesive. <br />C. Maintain dye lot integrity. Do not mix dye lots in same area. <br />D. Cut and fit carpet tile to butt tightly to vertical surfaces, permanent fixtures, and built -in <br />furniture including cabinets, pipes, outlets, edgings, thresholds, and nosings. Bind or seal cut <br />edges as recommended by carpet tile manufacturer. <br />E. Extend carpet tile into toe spaces, door reveals, closets, open- bottomed obstructions, removable <br />flanges, alcoves, and similar openings. <br />F. Maintain reference markers, holes, and openings that are in place or marked for future cutting <br />by repeating on finish flooring as marked on subfloor. Use nonpermanent, nonstaining marking <br />device. <br />G. Install pattern parallel to walls and borders. <br />3.4 CLEANING AND PROTECTION <br />A. Perform the following operations immediately after installing carpet tile: <br />1. Remove excess adhesive, seam sealer, and other surface blemishes using cleaner <br />recommended by carpet tile manufacturer. <br />2. Remove yarns that protrude from carpet tile surface. <br />3. Vacuum carpet tile using commercial machine with face - beater element. <br />CARPET TILE 096810-5 <br />