Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />E. Maintain reference markers, holes, and openings that are in place or marked for future cutting <br />by repeating on floor tiles as marked on substrates. Use chalk or other nonpermanent, <br />nonstaining marking device. <br />F. Install tiles on covers for telephone and electrical ducts and similar items in finished floor areas. <br />Maintain overall continuity of color and pattern with pieces of tile installed on covers. Tightly <br />adhere tile edges to substrates that abut covers and to cover perimeters. <br />G. Adhere tiles to flooring substrates using a full spread of adhesive applied to substrate to produce <br />a completed installation without open cracks, voids, raising and puckering at joints, <br />telegraphing of adhesive spreader marks, and other surface imperfections. <br />3.4 RESILIENT WALL BASE INSTALLATION <br />A. Apply wall base to walls, columns, pilasters, casework and cabinets in toe spaces, and other <br />permanent fixtures in rooms and areas where base is required. <br />B. Install wall base in lengths as long as practicable without gaps at seams and with tops of <br />adjacent pieces aligned. <br />C. Tightly adhere wall base to substrate throughout length of each piece, with base in continuous <br />contact with horizontal and vertical substrates. <br />D. Do not stretch wall base during installation. <br />E. On masonry surfaces or other similar irregular substrates, fill voids along top edge of wall base <br />with manufacturer's recommended adhesive filler material. <br />F. Premolded Corners: Install premolded corners before installing straight pieces. <br />3.5 RESILIENT ACCESSORY INSTALLATION <br />A. Resilient Molding Accessories: Butt to adjacent materials and tightly adhere to substrates <br />throughout length of each piece. Install reducer strips at edges of floor coverings that would <br />otherwise be exposed. <br />3.6 CLEANING AND PROTECTION <br />A. Perform the following operations immediately after completing resilient product installation: <br />1. Remove adhesive and other blemishes from exposed surfaces. <br />2. Sweep and vacuum surfaces thoroughly. <br />3. Damp -mop surfaces to remove marks and soil. <br />a. Do not wash surfaces until after time period recommended by manufacturer. <br />B. Protect resilient products from mars, marks, indentations, and other damage from construction <br />operations and placement of equipment and fixtures during remainder of construction period. <br />Use protection methods recommended in writing by manufacturer. <br />RESILIENT FLOOR TILE 096519-6 <br />