Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />4. Provide components with concealed fasteners and anchor and connection devices. <br />5. Fabricate components with accurately fitted joints with ends coped or mitered to produce <br />hairline joints free of burrs and distortion. <br />6. Fabricate exterior components to drain condensation and water passing joints within <br />system to the exterior. <br />7. Provide anchorage and alignment brackets for concealed support of assembly from <br />building structure. <br />8. Allow for thermal expansion of exterior units. <br />C. Doors: Factory fabricated and assembled in profiles indicated. Reinforce as required to support <br />imposed loads and for installing hardware. <br />D. Metal Cladding: Factory- fabricated and installed metal cladding, completely covering all visible <br />surfaces as part of prefabricated entrance assembly before shipment to Project site. <br />1. Perform fabrication operations in manner that prevents damage to exposed finish <br />surfaces. <br />2. Form profiles that are sharp, straight, and free of defects or deformations. <br />3. Provide components with concealed fasteners and anchor and connection devices. <br />4. Fabricate components with accurately fitted joints with ends coped or mitered to produce <br />hairline joints free of burrs and distortion. <br />5. Fabricate exterior components to drain water passing joints and condensation and <br />moisture occurring or migrating within system to the exterior. <br />6. Allow for thermal expansion at exterior entrances. <br />E. Door Operators: Factory fabricated and installed in headers, including adjusting and testing. <br />F. Glazing: Fabricate framing with minimum glazing edge clearances for thickness and type of <br />glazing indicated, according to GANA's "Glazing Manual." <br />G. Hardware: Factory install hardware to greatest extent possible; remove only as required for final <br />finishing operation and for delivery to and installation at Project site. Cut, drill, and tap for <br />factory- installed hardware before applying finishes. <br />1. Provide sliding -type weather stripping, mortised into door, at perimeter of doors and <br />breakaway sidelites. <br />H. Controls: <br />1. General: Factory install activation and safety devices in doors and headers as required by <br />BHMA Al56.10 for type of door and direction of travel. <br />2.9 GENERAL FINISH REQUIREMENTS <br />A. Protect mechanical finishes on exposed surfaces from damage by applying a strippable, <br />temporary protective covering before shipping. <br />B. Apply organic and anodic finishes to formed metal after fabrication unless otherwise indicated. <br />SLIDING AUTOMATIC ENTRANCES 084229-8 <br />