Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />1. Engineering Responsibility: Preparation of data for aluminum -framed systems including <br />Shop Drawings based on testing and engineering analysis of manufacturer's standard <br />units in assemblies similar to those indicated for this Project and submission of reports of <br />tests performed on manufacturer's standard assemblies. <br />B. Product Options: Information on Drawings and in Specifications establishes requirements for <br />systems' aesthetic effects and performance characteristics. Aesthetic effects are indicated by <br />dimensions, arrangements, alignment, and profiles of components and assemblies as they relate <br />to sightlines, to one another, and to adjoining construction. Performance characteristics are <br />indicated by criteria subject to verification by one or more methods including preconstruction <br />testing, field testing, and in- service performance. <br />1. Do not modify intended aesthetic effects, as judged solely by Architect, except with <br />Architect's approval. If modifications are proposed, submit comprehensive explanatory <br />data to Architect for review. <br />C. Accessible Entrances: Comply with FED - STD -795, "Uniform Federal Accessibility <br />Standards," and the "North Carolina Accessibility Code." <br />D. Welding: Qualify procedures and personnel according to AWS 131.2, "Structural Welding <br />Code -- Aluminum." <br />E. Structural- Sealant Glazing: Comply with recommendations in ASTM C 1401, "Guide for <br />Structural Sealant Glazing." <br />F. Structural- Sealant Joints: Design reviewed and approved by structural- sealant manufacturer. <br />G. Mockups: Build mockups to demonstrate aesthetic effects and set quality standards for <br />fabrication and installation. <br />1. Build mockup of typical wall area as shown on Drawings. <br />2. Field testing shall be performed on mockups according to requirements in Part 3 "Field <br />Quality Control" Article. <br />1.6 PROJECT CONDITIONS <br />A. Field Measurements: Verify actual locations of structural supports for aluminum- framed <br />systems by field measurements before fabrication and indicate measurements on Shop <br />Drawings. <br />1.7 WARRANTY <br />A. Special Assembly Warranty: Manufacturer's standard form in which manufacturer agrees to <br />repair or replace components of aluminum -framed systems that do not comply with <br />requirements or that deteriorate as defined in this Section within specified warranty period. <br />1. Failures include, but are not limited to, the following: <br />a. Structural failures including, but not limited to, excessive deflection. <br />b. Noise or vibration caused by thermal movements. <br />ALUMINUM- FRAMED STOREFRONTS 084110-4 <br />