Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />PART 3 - EXECUTION <br />3.1 PREPARATION <br />A. Before installation, condition woodwork to average prevailing humidity conditions in <br />installation areas. <br />B. Before installing architectural woodwork, examine shop- fabricated work for completion and <br />complete work as required, including removal of packing and backpriming. <br />3.2 INSTALLATION <br />A. Grade: Install woodwork to comply with requirements for the same grade specified in Part 2 for <br />fabrication of type of woodwork involved. <br />B. Assemble woodwork and complete fabrication at Project site to comply with requirements for <br />fabrication in Part 2, to extent that it was not completed in the shop. <br />C. Install woodwork level, plumb, true, and straight. Shim as required with concealed shims. <br />Install level and plumb (including tops) to a tolerance of 1/8 inch in 96 inches (3 mm in 2400 <br />mm). <br />D. Scribe and cut woodwork to fit adjoining work, refinish cut surfaces, and repair damaged finish <br />at cuts. <br />E. Fire - Retardant - Treated Wood: Handle, store, and install fire - retardant - treated wood to comply <br />with chemical treatment manufacturer's written instructions, including those for adhesives used <br />to install woodwork. <br />F. Anchor woodwork to anchors or blocking built in or directly attached to substrates. Secure with <br />countersunk, concealed fasteners and blind nailing as required for complete installation. Use <br />fine finishing nails or finishing screws for exposed fastening, countersunk and filled flush with <br />woodwork and matching final finish if transparent finish is indicated. <br />G. Cabinets: Install without distortion so doors and drawers fit openings properly and are <br />accurately aligned. Adjust hardware to center doors and drawers in openings and to provide <br />unencumbered operation. Complete installation of hardware and accessory items as indicated. <br />1. Install cabinets with no more than 1/8 inch in 96 -inch (3 mm in 2400 -mm) sag, bow, or <br />other variation from a straight line. <br />2. Maintain veneer sequence matching of cabinets with transparent finish. <br />3. Fasten wall cabinets through back, near top and bottom, at ends and not more than 16 <br />inches (400 mm) o.c. with toggle bolts through metal backing or metal framing behind <br />wall finish. <br />H. Countertops: Anchor securely by screwing through corner blocks of base cabinets or other <br />supports into underside of countertop. <br />INTERIOR ARCHITECTURAL WOODWORK 064021 -8 <br />