Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />1. Adhesive for Bonding Edges: Hot -melt adhesive or adhesive specified above for faces. <br />2.3 FABRICATION, GENERAL <br />A. Wood Moisture Content: Comply with requirements of referenced quality standard for wood <br />moisture content in relation to ambient relative humidity during fabrication and in installation <br />areas. <br />B. Sand fire - retardant - treated wood lightly to remove raised grain on exposed surfaces before <br />fabrication. <br />C. Fabricate woodwork to dimensions, profiles, and details indicated. Ease edges to radius <br />indicated for the following: <br />1. Corners of Cabinets and Edges of Solid -Wood (Lumber) Members and Rails: 1/16 inch <br />(1.5 mm). <br />D. Complete fabrication, including assembly, finishing, and hardware application, to maximum <br />extent possible before shipment to Project site. Disassemble components only as necessary for <br />shipment and installation. Where necessary for fitting at site, provide ample allowance for <br />scribing, trimming, and fitting. <br />1. Notify Architect seven days in advance of the dates and times woodwork fabrication will <br />be complete. <br />2. Trial fit assemblies at fabrication shop that cannot be shipped completely assembled. <br />Install dowels, screws, bolted connectors, and other fastening devices that can be <br />removed after trial fitting. Verify that various parts fit as intended and check <br />measurements of assemblies against field measurements indicated on Shop Drawings <br />before disassembling for shipment. <br />E. Shop -cut openings to maximum extent possible to receive hardware, appliances, plumbing <br />fixtures, electrical work, and similar items. Locate openings accurately and use templates or <br />roughing -in diagrams to produce accurately sized and shaped openings. Sand edges of cutouts <br />to remove splinters and burrs. <br />1. Seal edges of openings in countertops with a coat of varnish. <br />F. Install glass to comply with applicable requirements in Division 8 Section "Glazing" and in <br />GANA's "Glazing Manual." For glass in wood frames, secure glass with removable stops. <br />2.4 PLASTIC - LAMINATE CABINETS <br />A. Grade: Custom. <br />B. AWI Type of Cabinet Construction: Flush overlay. <br />C. Laminate Cladding for Exposed Surfaces: High - pressure decorative laminate complying with <br />the following requirements: <br />1. Horizontal Surfaces Other Than Tops: Grade HGS. <br />INTERIOR ARCHITECTURAL WOODWORK 064021-6 <br />