Orange County NC Website
Browse       Search
DocuSign Envelope ID: 313DA256 -1EDE- 4396- A716- 4C53B809027E <br />JERRY M. PASSMORE CENTER ADDITION AND RENOVATION <br />HILLSBOROUGH, NORTH CAROLINA <br />a. Solid Wood. <br />b. Composite Wood: Plywood, OSB, MDF and particleboard. <br />C. Treated, painted, or contaminated wood. <br />2. Separate wood waste in accordance with the Waste Management Plan and place in <br />designated areas in the following categories for reuse on site: <br />a. Sheet materials larger than 2 sq. ft. (1800 sq. cm). <br />b. Framing members longer than 24 inches (600 mm). <br />C. Multiple offcuts of any size larger than 12 inches (300mm). <br />Set aside damaged wood for acceptable alternative uses, such as bracing or blocking. <br />4. Fold up metal banding, flatten, and place in designated area for recycling. <br />5. Use the least toxic sealants, adhesives, sealers, cleaning agents and finishes necessary to <br />comply with the requirements of this Section. <br />PART 2 - PRODUCTS <br />2.1 WOOD PRODUCTS, GENERAL <br />A. Lumber: DOC PS 20 and applicable rules of lumber grading agencies certified by the American <br />Lumber Standards Committee Board of Review. <br />1. Factory mark each piece of lumber with grade stamp of grading agency. <br />2. For exposed lumber indicated to receive a stained or natural finish, mark grade stamp on <br />end or back of each piece. <br />3. Where nominal sizes are indicated, provide actual sizes required by DOC PS 20 for <br />moisture content specified. Where actual sizes are indicated, they are minimum dressed <br />sizes for dry lumber. <br />4. Provide dressed lumber, S4S, unless otherwise indicated. <br />5. Provide dry lumber with 19 percent maximum moisture content at time of dressing for 2- <br />inch nominal (38 -mm actual) thickness or less, unless otherwise indicated. <br />6. Provide dry lumber with 15 percent maximum moisture content at time of dressing for 2- <br />inch nominal (38 -mm actual) thickness or less, unless otherwise indicated. <br />B. Wood Structural Panels: <br />1. Plywood: Either DOC PS 1 or DOC PS 2, unless otherwise indicated. <br />2. Comply with "Code Plus" provisions in APA Form No. E30K, "APA <br />Design/Construction Guide: Residential & Commercial." <br />3. Factory mark panels according to indicated standard. <br />2.2 WOOD - PRESERVATIVE- TREATED MATERIALS <br />A. Preservative Treatment by Pressure Process: AWPA C2 (lumber) and AWPA C9 (plywood), <br />except that lumber that is not in contact with the ground and is continuously protected from <br />liquid water may be treated according to AWPA C31 with inorganic boron (SBX). <br />ROUGH CARPENTRY 061000-2 <br />