Orange County NC Website
D 6 <br /> space instead must be approved by the County <br /> Commissioners as a revision to the preliminary plan. <br /> • . The owners ' alternative plan is consistent with the <br /> intent of condition #5 since the strip of land is <br /> not to be combined with lot 1 . <br /> The other conditions have all been met on the final <br /> plat which is to be presented later in this meeting. <br /> The Planning Staff recommends approval of the <br /> revised preliminary plan of Sykes Glen, Phase 3, <br /> with the following conditions: <br /> 1 . On sheet 1, label the 30' drainage easement which <br /> crosses lots 8 and 7 . <br /> 2 . Revise sheet 1 to include the square footage of <br /> the open space and label it as "Property of Sykes <br /> Glen, Phase 3, Homeowners Association, Inc. " <br /> MOTION: Burklin moved acceptance of the Planning Staff <br /> recommendation. Seconded by Waddell. <br /> VOTE: Unanimous. <br /> b. Final Plats (22 Lots) <br /> (1) Sykes Glen - Phase 3 <br /> (22 Lots - Bingham Township) <br /> Presentation by Emily Crudup. <br /> Since the Planning Board has recommended approval <br /> of the revised preliminary plan for Sykes Glen, <br /> Phase 3, the preliminary application will be <br /> forwarded to the Board of Commissioners on <br /> February 5, 1990 . <br /> The Planning Staff recommends approval of the <br /> final plat of Sykes Glen, Phase 3, provided the <br /> preliminary plan is approved by the Board of <br /> County Commissioners to designate the area north <br /> of the entrance as common space and not part of <br /> lot 16 . <br /> Best asked why Staff was asking for preliminary <br /> and final approval at the same time. Crudup <br /> responded that the applicant desired to make the <br /> strip common open space rather than a part of Lot <br /> 16. If the Board of Commissioners did not <br /> approve this, then the final plat would be , <br /> redrawn and submitted by the applicant with the <br /> strip as part of Lot 16. <br /> Burklin asked why the change could not be made at <br />