Orange County NC Website
Browse       Search
DocuSign Envelope ID:A9CF8A9E-4CDB-4BB9-A678-D4AD80CD1393 <br /> SthWall Building Diagnostics Consultants Roof Replacement <br /> Central Recreation Center <br /> Hillsborough,NC <br /> August 2016 <br /> DIVISION 7 <br /> THERMAL AND MOISTURE PROTECTION <br /> SECTION 076200 <br /> SHEET METAL FLASHING AND TRIM <br /> PART 1 GENERAL <br /> 1.01 Related Documents <br /> Drawings and general provisions of the contract including General, Supplemental and Special <br /> Conditions, and other Division 1 specification sections apply to work of this section. <br /> 1.02 Work Included <br /> Installation of new edge trim. <br /> 1.03 Related Work <br /> A. Section 061000—Rough Carpentry <br /> B. Section 075217—Polymer Modified Bituminous Membrane Roofing(Cold Applied) <br /> C. Section 079200—Sealants and Caulking <br /> 1.04 Quality Assurance <br /> A. Qualifications of Manufacturer: Products used in the work of this section shall be <br /> produced by manufacturers regularly engaged in the manufacture of similar items and <br /> with a history of successful production acceptable to the Owner. <br /> B. Qualifications of Contractor: Use adequate number of skilled workmen who are <br /> thoroughly trained and experienced in the necessary crafts and are completely familiar <br /> with the specified requirements and the methods needed for the proper performance of <br /> the work in this section. <br /> C. In acceptance or rejection of the work of this section,the Owner shall make no allowance <br /> for lack of skill on the part of the workmen. <br /> 1.05 Shop Drawings <br /> A. Submit shop drawings in accordance with this specification. Shop drawings shall be <br /> scaled to clearly indicate all profiles and components. Minimum scale: 3"= 1 foot. <br /> B. Indicate material profile,jointing pattern,jointing details, fastening methods,termination <br /> details, and type and gauge of metal. <br /> C. Indicate locations of field applied sealant. <br /> 1.06 Submittals <br /> A. Submit samples in accordance with this specification. <br /> B. Submit a 12-inch length of each sheet metal configuration prior to fabrication. <br /> 16-171 Sheet Metal Flashing and Trim <br /> 076200-1 <br />