Agenda - 11-21-2016 - D-2 - Laserfiche WebLink

Browse Search

Article 7: Subdivision Section 7.13: Specifications for Plat Drawings (iii) Proposed streets, pavement or travelway widths shall be denoted as well as typical roadway cross sections. The approximate centerline radius shall be shown on all proposed streets. (iv) Proposed street names shall be indicated on the pl. . Such names shall not duplicate or approximate the nar e of any other street in Orange County except where a proposed street is the continuation or extension of an existing streo . (6) Utility and Drainage Data -) Proposed utility systems shall be shown on e plat, including but not limited to: i) Public or private community wa -r supply systems, (ii Public or private community sewage disposal systems, and (iii) Storm drainage facilities . cluding existing and proposed �rainageways and ch.,nels. (b) Any ease, ents associat:s with such utility systems shall also be denoted ang the purpo-- for the easements designated on the plat. (7) Landscaping and Buffe Da The following information : I be denoted on the Preliminary Plat to demonstrate complianc: ith 'e provisions of Section 6.8 of this Ordinance: (a) Existing tr:-s and/or vegetation to be preserved and proposed trees and/or I. dscape materia to be installed. (b) Req . ed buffers. (8) Special Fl••d Hazard Area (SFHA) Stan. •rds (a) The boundary of the Special Flood ' .zard Area zoning overlay district shall be designated and labeled on th- slat as required by this Ordinance. (b) For subdivisions located within a Watershes -rotection Overlay District, as identified on the Orange County Zs ing Atlas, the following information shall be designated and labeled on 'e plat: (i) Impervious surface data as required by Sectis 4.2 of this Ordinance; (ii) Stream buffers as required by Section 6.13 of this o dinance; and (iii) Stormwater detention and/or retention sites and undisturged areas for infiltration purposes as required by the Section 6.'4 of this Ordinance. 7.14.37.13.3 Final Plat Specifications (A) Plat Preparation (1) The Final Plat shall be drawn in accordance with the requirements of G.S. 47-30 as amended and to the specifications of this Section. The plat shall be prepared by a Professional Land Surveyor at a scale of not less than 100 feet to the inch nor more than 20 feet to the inch. (2) All Final Plats shall be prepared in accordance with the Manual of Practice for Land Surveying in North Carolina as prepared by the North Carolina State Board of Registration for Professional Engineers and Land Surveyors. Orange County, North Carolina—Unified Development Ordinance Page 7-71