Agenda - 02-25-2008-c2a - Laserfiche WebLink

Browse Search

tower. If an ANSI report has not been done pursuant to the preceding schedule, an ANSI report shall be done and submitted as part of the application. No Buildina Permit shall be issued for anv wireless support structure where the structure __ being attached to is in need of remediation, unless and until the County Planning and Inspections Department has approved all. 13) A Structural Report signed by a Professional Engineer licensed to do business in the State and bearing that engineer's currently valid stamp. showing the structural adeauacy of the wireless Support structure to accommodate the proposed modification or antenna arrav Collocation, including anv eauipment shelter. unless the equipment shelter is located on the lowest floor of a building: 14) If attaching to a structure other than a tower or where the proposed attachment is within thirty (30') feet of areas to which the public has or could reasonably have or pain access to documentation shall be provided, including all calculations proving that the potential exposure to RF radiation (i.e. Non-Ion Emitting Radiation), will be comply with the most recent FCC __- regulations governing RF radiation and exposure thereto. and radiation in excess of the FCC's permitted standards and anv portion(s) of the structure that would be exposed to RF radiation in excess of the FCC's permitted standards. Compliance with the FCC's regulations in such an instance the RF radiation from all facilities. at that location shall be included in the calculations to show the cumulative effect on anv area of the building or structure deemed accessible by the public or workers. Such report or analysis shall be signed and sealed by a Professional ____ Engineer licensed in the State. 15) If the modification or antenna arrav Collocation is thirty (30') feet or more above around level, then a signed document such as the FCC's "Checklist to Determine whether a .Wireless support structure may be Categorically Excluded" shall be provided to verify that the modification or antenna arrav co- loration will fully comply with the current FCC's RF emissions regulations. If not categorically excluded. a complete RF emissions study is reauired to enable compliance verification including providing all calculations so that such may be verified prior to issuance of a Buildina Permit: 16) If any section or portion of the structure to be attached to is not in compliance with the FCC's regulations regarding RF radiation, that section or portion -must be barricaded with a suitable barrier to discourage approaching into the area in excess of the FCC's regulations. and be marked off with yellow