Agenda - 09-16-1997 - 8d - Laserfiche WebLink

Browse Search

Full Text of Senate Bill 875 6 of curvature to point of tangency) must be shown on the plat. (5) Where a subdivision of land is set out on the plat, all streets and lots shall be accurately plotted with dimension lines indicating widths and all other information pertinent to reestablishing all lines in the field. This shall include bearings and distances sufficient to form a continuous closure of the entire perimeter. (6) Where control corners have been established in compliance with G.S. 39- 32.1, 39- 32.2, 39- 32.3, and 39- 32.4, as amended, the location and pertinent information as required in the reference statute shall be plotted on the plat. All other corners which are marked by monument or natural object shall be so identified on all plats, and where practical all corners of adjacent owners along the boundary lines of the subject tract which are marked by monument or natural object shall be shown. (7) The names of adjacent landowners, or lot, block, parcel, subdivision designations or other legal reference where applicable, shall be shown where they could be determined by the surveyor. (8) All visible and apparent rights- of- way, watercourses, utilities, roadways, and other such improvements shall be accurately located where crossing or forming any boundary line of the property shown. (9) Where the plat is the result of a survey, one or more corners shall, by a system of' azimuths or courses and distances, be accurately tied to and coordinated with a horizontal control monument of some United States or State Agency survey system, such as the North Carolina Geodetic Survey where such the monument is within 2,000 feet of the subject property. Where the North Carolina Grid System coordinates of said the monument are on file in the North +---larit- F idrnnmeni- Hcnl h and Ma iirnl T7 cnnr�cc Carolina D�..p.:- clf .n t��t e,T office of State Planning, the coordinates of both the referenced corner and the monuments used shall be shown in X (easting) and Y (northing) coordinates on the plat. The coordinates shall be identified as based on 'NAD 83, ' indicating North American Datum of 1983, or as -NAD 27, ' indicating North American Datum of 1927. The tie lines to the monuments shall also be sufficient to establish true north or grid north bearings for the plat if the monuments exist in pairs. within a previously recorded subdivision that has been tied to grid control, control monuments within the subdivision may be used in lieu of additional ties to grid control. within a previously recorded subdivision that has not been tied to grid control, if horizontal control monuments are available within 2,000 feet, the above requirements shall be met; but in ' the interest of bearing consistency with previously recorded plats, existing bearing control should be used where practical. In the absence of Grid Control, other appropriate natural monuments or landmarks shall be used. In all cases, the tie lines shall be sufficient to accurately reproduce the subject lands from the control or reference points used. (10) A vicinity map (location map) shall appear on the plat. (11) Notwithstanding any other provision contained in this section, it is the duty of the surveyor, by a certificate on the face of the plat, to certify to one of the following: a. That the survey creates a subdivision of land within the area of a county or municipality that has an ordinance that regulates parcels of land; b. That the survey is located in such a portion of a county or municipality that is unregulated as to an ordinance that regulates parcels of land; C. Any one of the following: k 1. That the survey is of 4 of 12 08/22/97 14:34:23