Orange County NC Website
Browse       Search
Administration Resolution to <br /> D. Drainage <br /> 1. The floodway and floodway fringe of USGA intermittent streams shall be noted <br /> on the face of the Final Plat. Development restrictions within the floodplain shall <br /> be specified on a document describing development restrictions and requirements <br /> to be prepared by Planning Staff and recorded concurrently with the Final Plat. <br /> The Homeowner's Association shall maintain the floodplain until it is conveyed <br /> to the County. <br /> 2. Impervious surface data, as pursuant to Article 6.23.3c.1 of the Zoning Ordinance <br /> shall be included in a document describing development restrictions and <br /> requirements to be prepared by Planning Staff and recorded concurrently with the <br /> Final Plat. The impervious surface limitations for each lot shall indicate the <br /> maximum impervious surface for each lot,net of the roadway(i.e. excluding <br /> roadway). <br /> 3. A stream buffer along McGowan Creek shall be provided in accordance with <br /> Section 6.23.7 of the Zoning Ordinance. The width of the buffer shall be stated <br /> on the face of plat. Development restrictions within the buffer shall be specified <br /> in a document describing development restrictions and requirements to be <br /> prepared by Planning Staff and recorded concurrently with the Final Plat. <br /> 4. Locate drainage easements on the Final Plat as required by Erosion Control Office <br /> in accordance with review and approval of the Erosion Control Plan. <br /> E. Parkland <br /> 1. See F.5. <br /> F. Miscellaneous <br /> 1. The Final Plat shall contain a title block and vicinity map in accordance with <br /> Section V-D-2 and V-D-3 of the Orange County Subdivision Regulations. <br /> 2. The following easements shall be shown on the plat: <br /> a. Drainage easements as required by DA above. <br /> b. Sewer system easements <br /> c. Water system easements <br /> d. Utility easements along right-of-ways. <br /> 3. The minimum building setback requirements and impervious surface maximums <br /> shall be stated on the Final Plat, and in a document describing development <br /> restrictions and requirements to be prepared by Planning Staff and recorded <br /> concurrently with the Final Plat. The impervious surface limitations for each lot <br /> shall indicate the maximum impervious surface for each lot, net of the roadway <br /> (i.e. excluding roadway). <br /> 4. Phasing of the project shall occur only in accordance with the Preliminary Plan. <br />