Orange County NC Website
Browse       Search
Article 3: Base Zoning Districts 18 <br /> Section 3.5: Industrial Districts <br /> DIMENSIONAL . RATIO STANDARDS <br /> MEDIUM 0 <br /> Lot Size, min., per use 20,000 <br /> (square feet) <br /> PURPOSE NR[1] 100 <br /> Lot Width, min. (feet) <br /> The purpose of the Medium Industrial-2(1-2) District is to provide NR-CU None <br /> locations for enterprises engaged in manufacturing, processing, <br /> creating,repairing, renovating, painting, cleaning,and Front Setback from NR 50 <br /> assembling of goods,merchandise or equipment. Performance ROW, min. (feet) NR-CU None <br /> standards will be used to insure the absence of adverse impact <br /> beyond the lot boundaries of the use. Side Setback, min. <br /> None[2] <br /> APPLICABILITY (feet) <br /> This district will usually be applied where the following <br /> conditions exist: Rear Setback, min. None[2] <br /> 1. Site is located within areas designated by the adopted (feet) <br /> Comprehensive Plan as a Commercial-Industrial Transition <br /> Activity Node. Height, max. (feet) 45[3] <br /> 2. Water and sewer mains exist at the site or be made available F=IeGFArea NR -38A <br /> as part of the development process. AIR-Gy -358 <br /> Floor Area Ratio, max. .65 <br /> #R <br /> ° N R--Gy -SBA <br /> DIMENSIONAL STANDARDS NOTES: Required Open Space .40 <br /> [1] R=residential, NR=non-residential, CU=conditional use. Ratio, min. <br /> [2]Required side and rear setbacks adjacent to residentially 298.998E <br /> zoned land shall be equal to the required side or rear setback of Gross Land Area, 634,144 <br /> the adjacent residential district. min./max. NR-CU 80,0001 <br /> [3]Two feet of additional height shall be allowed for one foot (square feet) <br /> none <br /> increase of the required front and side setbacks. RequiFed RJR -4-94 <br /> Rabe a�+r� <br /> NR-4_9 <br /> Required <br /> Pedestrian/Landscape .05 <br /> Ratio, min. <br /> DEVELOPMENT 1-2 DISTRICT SPECIFIC D• -D <br /> 1. Uses shall be restricted to those indicated for the 1-2 District in Section 5.2, unless a Conditional Use(CU)or <br /> MPD-CZ District is approved(see Section 3.8). Additionally, non-residential uses are restricted based on <br /> the Watershed Protection Overlay District in which the property is located. Refer to Section 4.2.3 for land <br /> use restrictions. <br /> 2. Development within the zoning district shall be subject to all applicable use standards detailed in Article 5 <br /> and all applicable development standards detailed in Article 6 of this Ordinance. See Sections 6.2.5 and <br /> 6.2.6 if more than one principal use or principal structure is proposed on a non-residential zoning lot. <br /> 3. Residential uses are not permitted in this district. <br /> 4. Allowable impervious surface area is based on the Watershed Protection Overlay District in which the <br /> property is located. Refer to Section 4.2.6 for a breakdown of the allowable impervious surface area. <br /> Additionally, Section 4.2.6 may require a larger lot size for non-residential uses than is contained in the <br /> Dimensional and Ratio Standards Table. <br /> 5. For lots outside of a Watershed Protection Overlay District see Section 4.2 ,the minimum usable lot area <br /> Orange County,North Carolina-Unified Development Ordinance Page 3-36 <br />