Orange County NC Website
Name: Alvin and Lorainne Burnette Page 6 of 16 ' J <br />Address: 104 Glossop Circle <br />City: Carrboro <br />• Phone #: 929-6458 <br />Date: 9/26/06- REVISED 1/22/07 <br />13. Supply and install new wiring and connections to accommodate new <br />switch control light in attic at same location. Supply and install new <br />switch control, with new switch to be located in crawlspace within 3 l.f. of <br />access door. <br />14. In Kitchen, supply and install new electrical to accommodate installation <br />of new range hood over existing stove with exhaust fan vented to exterior. <br />Supply and install new ducted range hood, complete. Duct to extend to <br />exterior of house. NOTE: Due to existing structural conditions new range <br />hood will be installed as close as possible to center over stove. <br /> <br />15. Supply and install new wiring and connections to maintain existing <br />exterior security light and accommodate new switch control to existing <br />ceiling light in storage room, new switch control to be located to inside <br />left of storage room door. Supply and install new switch control , <br />complete. <br />16. Remove existing wall light fixture in Bathroom. Repair electrical to <br />accommodate installation of new wall light fixture at same location. <br />Supply and install new incandescent wall light fixture in Bathroom. All <br />work complete and to code. <br />F. MECHANICAL <br />1. Make adjustments to existing HVAC trunk line and register boots to <br />accommodate installation of new insulated flexible ducting. Supply and <br />install insulation at existing trunk line, and new insulated flexible ducting <br />of minimum R-6 rating from trunk line to register boots. Includes all <br />necessary fittings, connections, sealant, complete. Supply and install new <br />registers. Service entire HVAC system to restore to proper working order. <br /> <br />Z. Where main duct passes through opening in rear wall of house, supply <br />and install new steel lintel with steel vertical supports on each end, all <br />properly connected to existing brick siding, including mortar packed <br />between steel members and existing brick. Width of new lintel to match <br />• <br />